PG-FP5-EA Renesas Electronics America, PG-FP5-EA Datasheet - Page 100

• Manufacturer Part Number: PG-FP5-EA
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP5-EA

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

<R>
PG-FP5
R20UT0008EJ0400 Rev. 4.00
Jul 15, 2010
[Disable Chip Erase] check box
If the [Set Security] command is executed with this check box selected, the [Erase] command will be disabled for
the entire area of the flash memory in the target device. When this check box is selected, the following dialog box
appears.
Clicking the OK button determines the selection of the [Disable Chip Erase] check box.
Clicking the Cancel button cancels the selection of the [Disable Chip Erase] check box.
[Disable Block Erase] check box
If the [Set Security] command is executed with this check box selected, the [Erase] command is disabled for all
the selected blocks in the flash memory selected with “Block” in the [Operation Mode] area on the [Standard] tab
in the Device Setup dialog box. This setting is cleared if the [Erase] command is executed with “Chip” selected in
the [Operation Mode] area.
[Disable Program] check box
If the [Set Security] command is executed with this check box selected, the [Erase] command for all the selected
blocks in the flash memory selected with “Block” in the [Operation Mode] area on the [Standard] tab in the Device
Setup dialog box and the [Program] command is disabled. This setting is cleared if the [Erase] command is
executed with “Chip” selected in the [Operation Mode] area.
[Disable Read] check box
If the [Set Security] command is executed with this check box selected, the [Read] command is disabled. This
setting is cleared if the [Erase] command is executed with “Chip” selected in the [Operation Mode] area.
[Disable Boot block cluster reprogramming] check box
If the [Set Security] command is executed with this check box selected, the boot block set in the [Boot Block end]
drop-down list is regarded as the last block in the [Block protection settings] area and then the boot area is set,
and rewriting to the area is prohibited. If this check box is selected, the following dialog box appears.
[Disable FSW re-setting] check box
If the [Set Security] command is executed with this check box selected, rewriting the block specified by using the
[FSW Block start] and [FSW Block end] drop-down lists in the [Block protection settings] area is disabled. This
setting is cleared if the [Erase] command is executed with “Chip” selected in the [Operation Mode] area.
Caution If the [Disable Chip Erase] function is enabled, erasure for the device will no longer be possible,
and the [Disable Chip Erase] function will no longer be able to be disabled.
Figure 4-71. [Disable Chip Erase] Warning Dialog Box
CHAPTER 4 PROGRAMMING GUI USAGE
Page 100 of 240