PG-FP5-EA Renesas Electronics America, PG-FP5-EA Datasheet - Page 210

• Manufacturer Part Number: PG-FP5-EA
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP5-EA

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PG-FP5
R20UT0008EJ0400 Rev. 4.00
Jul 15, 2010
I 2211
I 2212
I 2213
I 2214
I 2215
I 2216
I 2300
I 2302
I 2401
I 2402
I 2411
I 2412
I 2413
I 2414
I 2415
No.
Updating the FPGA will take several minutes.
ATTENTION:
-The process of updating your FPGA must NOT be
interrupted!
-Without FPGA this FP5 GUI will NOT run properly.
Install new FPGA in your programmer?
You must be careful before start Self-test.
ATTENTION:
-Remove any plugs from Target- and
Remote-connector before starting.
-Any hardware attached to those connectors may be
damaged by this test!
Start Self-test?
Project folder and parameter file is not defined.
Click button [Yes] if create the setting file newly
Click button [No] if select the existing setting file
Parameter setting file is not defined.
use most recent setting as default
Selected parameter files are copied to specified project
folder.
<Parameter file name> already exists. Do you want
overwrites the existing file?
Value out of range.
Please give file range
Caution: When 'Chip Erase' is disabled, chip cannot be
erased and programmed any more!
Caution: When 'Boot block cluster reprogramming' is
disabled, chip cannot be erased and programmed any
more!
The selection is out of range.
The selection is out of range.
Value is out of range.
Value is out of range.
The selection is out of range.
Message
The FPGA update will take several minutes.
ATTENTION:
The FP5 may not operate normally if a proper FPGA is not
installed.
Select whether to update the FPGA.
Note the following points before performing self-testing.
ATTENTION:
Unplug all target connectors and remote connectors.
If any hardware is connected, it may be damaged by this
testing.
User selected parameter files are copied to the destination.
The set value is out of the valid ranges. The valid code
flash range is 0-0x400000. The valid data flash range is
0x400000 to 0x420000.
Input the file range. No arguments are specified for the
range.
If Chip Erase is disabled, the flash memory in the target
device cannot be erased or rewritten.
If Boot block cluster reprogramming is disabled, the flash
memory in the target device cannot be erased or rewritten.
The selected communication speed is higher than the
maximum value defined in the PR5 file.
The selected communication speed is lower than the
minimum value defined in the PR5 file.
The selected clock value is larger than the maximum value
defined in the PR5 file.
The selected clock value is smaller than the minimum value
defined in the PR5 file.
The V
DD
value exceeds the range defined in the PR5 file.
Description
APPENDIX A MESSAGES
−
−
−
Page 210 of 240
(2/3)