M1AFS250-FGG256I Actel Corporation, M1AFS250-FGG256I Datasheet - Page 52

• Manufacturer Part Number: M1AFS250-FGG256I
• Description: Actel Fusion Family Of Mixed Signal Fpgas
• Manufacturer: Actel Corporation

Device Architecture
2- 36
Example: Calculation for Match Count
To put the Fusion device on standby for one hour using an external crystal of 32.768 KHz:
The period of the crystal oscillator is T
The period of the counter is T
The Match Count for 1 hour is Δtmatch:
Δtmatch / T
Using a 32.768 KHz crystal, the maximum standby time of the 40-bit counter is 4,294,967,296 seconds,
which is 136 years.
Table 2-16 • RTC Control/Status Register
Bit
7
6
5
4:3
2
1
0
T
T
crystal
counter
xt_mode[1:0]
rst_cnt_omat
vr_en_mat
= 1 / 32.768 KHz = 30.518 µs
rstb_cnt
cntr_en
counter
xtal_en
= 30.518 us X 128 = 3.90625 ms
rtc_rst
Name
= (1 hr X 60 min/hr X 60 sec/min) / 3.90625 ms = 921600 or 0xE1000
RTC Reset
1 – Resets the RTC
0 – Deassert reset on after two ACM_CLK cycle.
Counter Enable
1 – Enables the counter; rtc_rst must be deasserted as well. First
counter increments after 64 RTCCLK positive edges.
0 – Disables the crystal prescaler but does not reset the counter
value. Counter value can only be updated when the counter is
disabled.
Voltage Regulator Enable on Match
1 – Enables RTCMATCH and RTCPSMMATCH to output 1 when the
counter value equals the Match Register value. This enables the 1.5 V
voltage
RTCPSMMATCH signal in VRPSM.
0 – RTCMATCH and RTCPSMMATCH output 0 at all times.
Crystal Mode
Controls RTCXTLMODE[1:0]. Connects to RTC_MODE signal in
XTLOSC. XTL_MODE uses this value when xtal_en is 1. See the
"Crystal Oscillator" section on page 2-21
Reset Counter on Match
1 – Enables the sync clear of the counter when the counter value
equals the Match Register value. The counter clears on the rising
edge of the clock. If all the Match Registers are set to 0, the clear is
disabled.
0 – Counter increments indefinitely
Counter Reset, active Low
0 - Resets the 40-bit counter value
Crystal Enable
Controls RTCXTLSEL. Connects to SELMODE signal in XTLOSC.
0 – XTLOSC enables control by FPGA_EN; xt_mode is not used.
Sleep mode requires this bit to equal 0.
1 – Enables XTLOSC, XTL_MODE control by xt_mode
Standby mode requires this bit to be set to 1.
See the
SELMODE configuration.
counter
"Crystal Oscillator" section on page 2-21
regulator
:
crystal
:
R e visio n 1
when
Description
RTCPSMMATCH
for mode configuration.
for further details on
connects
to
the
Default
Value
00
0
0
0
0
0