HYB18T512160A Infineon Technologies AG, HYB18T512160A Datasheet - Page 58

• Manufacturer Part Number: HYB18T512160A
• Description: 512-Mbit Double-Data-Rate-Two SDRAM
• Manufacturer: Infineon Technologies AG

Figure 52
2.9.2
The Self-Refresh command can be used to retain data,
even if the rest of the system is powered down. When
in the Self-Refresh mode, the DDR2 SDRAM retains
data without external clocking. The DDR2 SDRAM
device has a built-in timer to accommodate Self-
Refresh operation. The Self-Refresh Command is
defined by having CS, RAS, CAS and CKE held low
with WE high at the rising edge of the clock. ODT must
be turned off before issuing Self Refresh command, by
either driving ODT pin low or using EMRS(1)
command. Once the command is registered, CKE must
be held low to keep the device in Self-Refresh mode.
The DLL is automatically disabled upon entering Self
Refresh and is automatically enabled upon exiting Self
Refresh. When the DDR2 SDRAM has entered Self-
Refresh mode all of the external control signals, except
CKE, are “don’t care”. The DRAM initiates a minimum
of one Auto Refresh command internally within
period once it enters Self Refresh mode. The clock is
internally disabled during Self-Refresh Operation to
save power. The minimum time that the DDR2 SDRAM
must remain in Self Refresh mode is
change the external clock frequency or halt the external
Data Sheet
CMD
CKE
CK, CK
P re ch a rg e
T0
"high"
Auto Refresh Timing
Self-Refresh Command
T1
N O P
> = t
R P
T2
N O P
t
CKE
. The user may
R E F R E S H
T3
A U T O
> = t
t
CKE
R F C
N O P
58
clock one clock after Self-Refresh entry is registered,
however, the clock must be restarted and stable before
the device can exit Self-Refresh operation.
The procedure for exiting Self Refresh requires a
sequence of commands. First, the clock must be stable
prior to CKE going back HIGH. Once Self-Refresh Exit
command is registered, a delay of at least
be satisfied before a valid command can be issued to
the device to allow for any internal refresh in progress.
CKE must remain high for the entire Self-Refresh exit
period
Refresh, the DDR2 SDRAM can be put back into Self
Refresh mode after
commands must be registered on each positive clock
edge during the Self-Refresh exit interval
should be turned off during
The use of Self Refresh mode introduces the possibility
that an internally timed refresh event can be missed
when CKE is raised for exit from Self Refresh mode.
Upon exit from Self Refresh, the DDR2 SDRAM
requires a minimum of one extra auto refresh command
before it is put back into Self Refresh Mode.
512-Mbit Double-Data-Rate-Two SDRAM
HYB18T512[400/800/160]A[C/F]–[3.7/5]
R E F R E S H
t
A U T O
XSRD
for proper operation. Upon exit from Self
N O P
t
XSNR
> = t
expires. NOP or deselect
t
XSNR
R F C
N O P
Functional Description
09112003-SDM9-IQ3P
.
Rev. 1.13, 2004-05
A N Y
t
XSNR
t
XSNR
. ODT
AR
must