FDC37N769_07 SMSC [SMSC Corporation], FDC37N769_07 Datasheet - Page 26
FDC37N769_07
Manufacturer Part Number
FDC37N769_07
Description
3.3V Super I/O Controller with Infrared Support for Portable Applications
Manufacturer
SMSC [SMSC Corporation]
Datasheet
1.FDC37N769_07.pdf
(137 pages)
- Current page: 26 of 137
- Download datasheet (670Kb)
DATA REGISTER (FIFO)
The Data Register (Base Address + 5) is used to transfer all command parameter information, disk data and result
status between the host processor and the floppy disk controller. The Data Register is Read/Write. Data transfers are
governed by the RQM and DIO bits in the Main Status Register.
The Data Register defaults to FIFO disabled mode after any form of reset.
compatibility. The default values can be changed through the Configure command (enable full FIFO operation with
threshold control). The advantage of the FIFO is that it allows the system a larger DMA latency without causing a
disk error. Table 25 gives several examples of service delays with a FIFO. The data is based upon the following
formula:
Threshold# × (8 ÷ Data Rate) - 1.5μS = DELAY
At the start of a command the FIFO action is always disabled and command parameters must be sent based upon the
RQM and DIO bit settings. As the command execution phase is entered, the FIFO is cleared of any data to ensure
that invalid data is not transferred.
An overrun or underrun will terminate the current command and the transfer of data. Disk writes will complete the
current sector by generating a 00 pattern and valid CRC. Reads require the host to remove the remaining data so
that the result phase may be entered.
SMSC DS – FDC37N769
DRT1
DRIVE RATE
0
0
1
DRT0
0
1
0
Table 23 - Drive Rate Table (Recommended)
Table 24 - Default Precompensation Delays
DATA RATE
360K, 1.2M, 720K, 1.44M and 2.88M Vertical Format
3-Mode Drive
2 Meg Tape
500 Kbps
300 Kbps
250 Kbps
2 Mbps
1 Mbps
DATASHEET
CR0B on page 104 to program Drive Rate)
Page 26 of 137
PRECOMPENSATION
(see section
FORMAT
DELAYS
41.67 ns
125 ns
125 ns
125 ns
125 ns
This maintains PC/AT hardware
Rev. 02-16-07
Related parts for FDC37N769_07
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
FAST ETHERNET PHYSICAL LAYER DEVICE
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
357-036-542-201 CARDEDGE 36POS DL .156 BLK LOPRO
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
357-036-542-201 CARDEDGE 36POS DL .156 BLK LOPRO
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
357-036-542-201 CARDEDGE 36POS DL .156 BLK LOPRO
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
4-PORT USB2.0 HUB CONTROLLER
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
FDC37C672ENHANCED SUPER I/O CONTROLLER WITH FAST IR
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
COM90C66LJPARCNET Controller/Transceiver with AT Interface and On-Chip RAM
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
SMSC Corporation
Datasheet: