mc68hc908mr32 Freescale Semiconductor, Inc, mc68hc908mr32 Datasheet - Page 41

no-image

mc68hc908mr32

Manufacturer Part Number
mc68hc908mr32
Description
M68hc08 Microcontrollers
Manufacturer
Freescale Semiconductor, Inc
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
mc68hc908mr32CB
Manufacturer:
FREESCALE
Quantity:
1 831
Part Number:
mc68hc908mr32CB
Manufacturer:
MOT
Quantity:
59
Part Number:
mc68hc908mr32CFU
Manufacturer:
FREESCALE
Quantity:
3
Part Number:
mc68hc908mr32CFU
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
2.8.4 FLASH Program Operation
Use the following step-by-step procedure to program a row of FLASH memory.
flowchart of the programming algorithm.
This program sequence is repeated throughout the memory until all data is programmed.
1. The time between each FLASH address change, or the time between the last FLASH address programmed to clearing PGM
Freescale Semiconductor
10. Clear the PGM bit
11. Wait for time, t
12. Clear the HVEN bit.
13. After time, t
bit, must not exceed the maximum programming time, t
1. Set the PGM bit. This configures the memory for program operation and enables the latching of
2. Read the FLASH block protect register.
3. Write any data to any FLASH location within the address range desired.
4. Wait for a time, t
5. Set the HVEN bit.
6. Wait for a time, t
7. Write data to the FLASH address being programmed
8. Wait for time, t
9. Repeat step 7 and 8 until all desired bytes within the row are programmed.
address and data for programming.
Only bytes which are currently $FF may be programmed.
The COP register at location $FFFF should not be written between steps
5-12, when the HVEN bit is set. Since this register is located at a valid
FLASH address, unpredictable behavior may occur if this location is written
while HVEN is set.
Programming and erasing of FLASH locations cannot be performed by
code being executed from the FLASH memory. While these operations
must be performed in the order shown, other unrelated operations may
occur between the steps. Do not exceed t
Memory
RCV
PROG
NVH
(typical 1 µs), the memory can be accessed in read mode again.
NVS
PGS
Characteristics.
(1)
(minimum 5 µs).
MC68HC908MR32 • MC68HC908MR16 Data Sheet, Rev. 6.1
.
(minimum 30 µs).
(minimum 10 µs).
(minimum 5 µs).
PROG
NOTE
NOTE
NOTE
maximum.
PROG
(1)
maximum, see
.
19.6 FLASH
Figure 2-4
FLASH Memory (FLASH)
shows a
41

Related parts for mc68hc908mr32