ADUC7060 Analog Devices, ADUC7060 Datasheet - Page 83

• Manufacturer Part Number: ADUC7060
• Description: Low-Power, Precision Analog Microcontroller, Dual ?-? ADCs, Flash/EE, ARM7TDMI
• Manufacturer: Analog Devices

Specifications of ADUC7060

• Mcu Core: ARM7 TDMI
• Mcu Speed (mips): 10
• Sram (bytes): 4096Bytes
• Gpio Pins: 14
• Adc # Channels: 10
• Other: 14 Bit DAC,PWM

UART Control Register 1
This 8-bit register controls the operation of the UART in
conjunction with COMCON0.
COMCON1 Register
Name:
Address:
Default value:
Access:
Table 90. COMCON1 MMR Bit Designations
Bit
7:5
4
3:2
1
0
UART Status Register 0
COMSTA0 Register
Name:
Address:
Default value:
Access:
Function:
Name
LOOPBACK
RTS
DTR
COMCON1
0x00
Read and write
COMSTA0
0x60
Read only
This 8-bit read-only register reflects the
current status on the UART.
0xFFFF0710
0xFFFF0714
Description
Reserved bits. Not used.
Loopback. Set by user to enable
loopback mode. In loopback mode,
the transmit pin is forced high.
Reserved bits. Not used.
Request to send.
Set by user to force the RTS output to 0.
Cleared by user to force the RTS
output to 1.
Data terminal ready.
Set by user to force the DTR output to 0.
Cleared by user to force the DTR
output to 1.
Rev. C | Page 83 of 108
Table 91. COMSTA0 MMR Bit Designations
Bit
7
6
5
4
3
2
1
0
Name
TEMT
THRE
BI
FE
PE
OE
DR
Description
Reserved.
COMTX and shift register empty status bit.
Set automatically if COMTX and the shift
register are empty. This bit indicates that
the data has been transmitted, that is, no
more data is present in the shift register.
Cleared automatically when writing to
COMTX.
COMTX empty status bit.
Set automatically if COMTX is empty.
COMTX can be written as soon as this bit
is set; the previous data might not have
been transmitted yet and can still be
present in the shift register.
Cleared automatically when writing to
COMTX.
Break indicator.
Set when P1.0/IRQ1/SIN/T0 pin is held
low for more than the maximum word
length.
Cleared automatically.
Framing error.
Set when the stop bit is invalid.
Cleared automatically.
Parity error.
Set when a parity error occurs.
Cleared automatically.
Overrun error.
Set automatically if data is overwritten
before being read.
Cleared automatically.
Data ready.
Set automatically when COMRX is full.
Cleared by reading COMRX.
ADuC7060/ADuC7061