AT32UC3A1512AU Atmel Corporation, AT32UC3A1512AU Datasheet - Page 385

• Manufacturer Part Number: AT32UC3A1512AU
• Manufacturer: Atmel Corporation

Specifications of AT32UC3A1512AU

• Flash (kbytes): 512 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 69
• Ext Interrupts: 69
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 6
• Twi (i2c): 1
• Uart: 4
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 16
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Operating Voltage (vcc): 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 10
• Output Compare Channels: 16
• Input Capture Channels: 6
• Pwm Channels: 13
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

32058K AVR32-01/12
27.6.5.2
Early Read Wait State
In some cases, the SMC inserts a wait state cycle between a write access and a read access to
allow time for the write cycle to end before the subsequent read cycle begins. This wait state is
not generated in addition to a chip select wait state. The early read cycle thus only occurs
between a write and read access to the same memory device (same chip select).
• An early read wait state is automatically inserted if at least one of the following conditions is
• if the write controlling signal has no hold time and the read controlling signal has no setup time
• in NCS write controlled mode (WRITE_MODE = 0), if there is no hold timing on the NCS signal
• in NWE controlled mode (WRITE_MODE = 1) and if there is no hold timing (NWE_HOLD = 0),
Figure 27-18. Early Read Wait State: Write with No Hold Followed by Read with No Setup.
valid:
(Figure
and the NCS_RD_SETUP parameter is set to 0, regardless of the read mode
The write operation must end with a NCS rising edge. Without an Early Read Wait State, the
write operation could not complete properly.
the feedback of the write control signal is used to control address, data, chip select and byte
select lines. If the external write control signal is not inactivated as expected due to load
capacitances, an Early Read Wait State is inserted and address, data and control signals are
maintained one more cycle. See
NBS0, NBS1,
A0, A1
27-18).
CLK_SMC
A[25:2]
D[15:0]
NWE
NRD
Write cycle
Figure
No hold
27-20.
Early Read
Wait state
No setup
Read cycle
AT32UC3A
(Figure
27-19).
385