MC9S12E128CPV Freescale Semiconductor, MC9S12E128CPV Datasheet - Page 513

• Manufacturer Part Number: MC9S12E128CPV
• Description: Microcontrollers (MCU) 16 Bit 16MHz
• Manufacturer: Freescale Semiconductor

Specifications of MC9S12E128CPV

• Data Bus Width: 16 bit
• Program Memory Type: Flash
• Program Memory Size: 128 KB
• Data Ram Size: 8 KB
• Interface Type: SCI, SPI
• Maximum Clock Frequency: 25 MHz
• Number Of Programmable I/os: 92
• Number Of Timers: 16 bit
• Operating Supply Voltage: 3.135 V to 5.5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: LQFP-112
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit
• On-chip Dac: 8 bit, 2 Channel
• Lead Free Status / Rohs Status: No RoHS Version Available

Chapter 18
Multiplexed External Bus Interface (MEBIV3)
18.1
This section describes the functionality of the multiplexed external bus interface (MEBI) sub-block of the
S12 core platform. The functionality of the module is closely coupled with the S12 CPU and the memory
map controller (MMC) sub-blocks.
Figure 18-1
pins that are accessible externally. On some chips, these may not all be bonded out.
The MEBI sub-block of the core serves to provide access and/or visibility to internal core data
manipulation operations including timing reference information at the external boundary of the core and/or
system. Depending upon the system operating mode and the state of bits within the control registers of the
MEBI, the internal 16-bit read and write data operations will be represented in 8-bit or 16-bit accesses
externally. Using control information from other blocks within the system, the MEBI will determine the
appropriate type of data access to be generated.
18.1.1
The block name includes these distinctive features:
Freescale Semiconductor
•
•
•
•
•
•
•
•
•
External bus controller with four 8-bit ports A,B, E, and K
Data and data direction registers for ports A, B, E, and K when used as general-purpose I/O
Control register to enable/disable alternate functions on ports E and K
Mode control register
Control register to enable/disable pull resistors on ports A, B, E, and K
Control register to enable/disable reduced output drive on ports A, B, E, and K
Control register to configure external clock behavior
Control register to configure IRQ pin operation
Logic to capture and synchronize external interrupt pin inputs
Introduction
Features
is a block diagram of the MEBI. In
MC9S12E128 Data Sheet, Rev. 1.07
Figure
18-1, the signals on the right hand side represent
513