LFXP10C-3F388I Lattice, LFXP10C-3F388I Datasheet - Page 232

• Manufacturer Part Number: LFXP10C-3F388I
• Description: FPGA LatticeXP Family 10000 Cells 320MHz 130nm (CMOS) Technology 1.8V/2.5V/3.3V 388-Pin FBGA Tray
• Manufacturer: Lattice

Specifications of LFXP10C-3F388I

• Package: 388FBGA
• Family Name: LatticeXP
• Device Logic Units: 10000
• Maximum Internal Frequency: 320 MHz
• Typical Operating Supply Voltage: 1.8|2.5|3.3 V
• Maximum Number Of User I/os: 244
• Ram Bits: 221184
• Re-programmability Support: Yes
• Lead Free Status / Rohs Status: Contains lead / RoHS non-compliant

Lattice Semiconductor
DQS Postamble
At the end of a READ cycle, the DDR SDRAM device executes the READ cycle postamble and then immediately
tristates both the DQ and DQS output drivers. Since neither the memory controller (FPGA) nor the DDR SDRAM
device are driving DQ or DQS at that time, these signals float to a level determined by the off-chip termination
resistors. While these signals are floating, noise on the DQS strobe may be interpreted as a valid strobe signal by
the FPGA input buffer. This can cause the last READ data captured in the IOL input DDR registers to be overwrit-
ten before the data has been transferred to the free running resynchronization registers inside the FPGA.
Figure 10-14. Postamble Effect on READ
LatticeECP/EC and LatticeXP devices have extra dedicated logic in the in the DQS Delay Block that will prevent
this postamble problem. The DQS postamble logic is automatically implemented when the user instantiates the
DQS Delay logic (DQSBUFB software primitive) in a design.
This postamble solution was implemented in all the devices of the LatticeECP/EC and LatticeXP families except
the LFEC20/LFECP20 device. For this device, it is recommended that the user issue an extra READ command to
assure correct data has been transferred to the synchronization registers.
The circumstances under which the extended READ cycle is issued are given in Table 10-8.
Table 10-8. DDR Read Postamble
Read (Row x, Bank y)
Read (any address)
Read (Row x, Bank y)
Read (Row x, Bank y)
Read (any address)
1. Current read is extended one or more additional clock cycles.
Current Command
Read (Row x, Bank y)
NOP
Read (Row n, Bank y)
Read (Row x, Bank n)
Write/LMR
DQS at PIN
DQS at IOL
DATAIN_N
DATAIN_P
DQ at PIN
DQ at IOL
synce reg
Next Command
CLK at
C
A
B
None.
Extend the current read command.
Extend the current read to (Row x, Bank y) consecutive to
current command
If the Row x, Bank n was open, do nothing. Else, extend
the current read to Row x, Bank y
Extend the current read command.
P0
P0
10-13
P0
N0
N0
P1
P1
Action
N0
P0
P0
N0
P1
N1
N1
1
LatticeECP/EC and LatticeXP
N1
P1
DDR Usage Guide
Lost Cycles
None
3
3
3
3