MTCMR-H4-P1-GB/IE Multi-Tech Systems, MTCMR-H4-P1-GB/IE Datasheet - Page 95

• Manufacturer Part Number: MTCMR-H4-P1-GB/IE
• Description: MODEM CELLULAR QUAD GPRS HSPA
• Manufacturer: Multi-Tech Systems
• Series: MultiModem® iCellr

Specifications of MTCMR-H4-P1-GB/IE

• Function: Transceiver, HSPA, Modem
• Modulation Or Protocol: GPRS, GSM, EDGE
• Frequency: 850MHz, 900MHz, 1.8GHz, 1.9GHz
• Applications: General Purpose
• Interface: RS-232, USB
• Data Rate - Maximum: 7.2 Mbps
• Features: UK Power Cord
• Voltage - Supply: 9 V ~ 32 V, USB
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 881-1122

High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A)
Note:
<SDU error ratio>
<Residual bit error ratio>
<Delivery of erroneous SDUs>
<Transfer delay>
<Traffic handling priority>
<PDP_type>
All QOS settings will be stored non volatile.
This parameter indicates the target value for the fraction of SDUs lost or detected as
erroneous. SDU error ratio is defined only for conforming traffic. The value is
specified as “mEe”. As an example a target SDU error ratio of 5*10-
specified as “5E3” (e.g., AT+CGEQREQ=...,”5E3”,...).
“0E0“
“1E2“
“7E3“
“1E3“
“1E4“
“1E5“
“1E6“
“1E1“
This parameter indicates the target value for the undetected bit error ratio in the
delivered SDUs. If no error-detection is requested, Residual bit error ratio indicates
the bit error ratio in the delivered SDUs. The value is specified as “mEe”. As an
example a target residual bit error ratio of 5*10-3 would be specified as “5E3” (e.g.,
AT+CGEQREQ=...,”5E3”,...).
“0E0“
“5E2“
“1E2“
“5E3“
“4E3“
“1E3“
“1E4“
“1E5“
“1E6“
“6E8“
This parameter indicates whether SDUs detected as erroneous shall be delivered or
not.
0
1
2
3
This parameter indicates the targeted time between request to transfer an SDU at
one SAP to its delivery at the other SAP, in milliseconds.
0
10...150
200...950
1000...4000 (value needs to be divisible by 100 without remainder)
This parameter specifies the relative importance for handling of all SDUs belonging
to the UMTS bearer compared to the SDUs of the other bearers.
0
1
2
3
Packet Data Protocol Type
“IP“ Internet Protocol (IETF STD 5)
No
Yes
No detect
Subscribed value. Default
Default. subscribed value.
Subscribed. Default
Subscribed value. Default
Subscribed value. Default
(value needs to be divisible by 10 without remainder)
(value needs to be divisible by 50 without remainder)
Chapter 3 – Supported GSM/WCDMA AT Commands
3
would be
95