CRT1-OD16SL-1 Omron, CRT1-OD16SL-1 Datasheet - Page 435

• Manufacturer Part Number: CRT1-OD16SL-1
• Description: 16 Out PNP Cage Clamp
• Manufacturer: Omron

Specifications of CRT1-OD16SL-1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

9-3
9-3-1
Input Section Specifications
Bit Slave Units with e-CON Connectors
Bit Slave Units with e-CON Connectors
Two-point Input Units
CRT1B-ID02S/CRT1B-ID02S-1
Model
I/O capacity
Internal I/O common
ON voltage
OFF voltage
OFF current
Input current
Sensor power supply voltage
ON delay
OFF delay
Number of circuits per com-
mon
Power short-circuit detection
Isolation method
Input indicators
Degree of protection
Installation
Power supply type
Communications power sup-
ply current consumption (See
note.)
Input device supply current
Weight
Item
Note The current consumption is for Bit Slave Unit communications cur-
2 inputs
NPN
10.5 VDC min. (between each input
terminal and the V terminal)
5 VDC max. (between each input ter-
minal and the V terminal)
1.0 mA max.
3.0 mA min./input (at 10.5 VDC)
Communications power supply voltage 0 V (max.)
Communications power supply voltage −1 V (min.)
1.5 ms max.
1.5 ms max.
2 inputs/common
Supported.
No isolation
LEDs (yellow)
IEC standard IP20
Screw installation (M4)
Network power supply
65 mA max. for 24-VDC power sup-
ply voltage
80 mA max. for 14-VDC power sup-
ply voltage
80 mA/2 points
70 g max.
rent when all inputs are OFF, i.e., it does not include input device
current consumption. The communications power supply is also
used for the I/O power supply for sensors. Be sure to consider the
sensor current consumption and the number of sensors connected
in addition to the communications power. The power supply current
consumption is expressed by the following formula.
Communications power supply current consumption = Bit Slave
Unit communications current consumption + (Bit Slave Unit input
current × number of inputs used) + (sensor current consumption ×
number of sensors used)
CRT1B-ID02S
Specification
PNP
10.5 VDC min. (between each input
terminal and the G terminal)
5 VDC max. (between each input ter-
minal and the G terminal)
45 mA max. for 24-VDC power sup-
ply voltage
65 mA max. for 14-VDC power sup-
ply voltage
CRT1B-ID02S-1
Section 9-3
411