CRT1-ID16TAH Omron, CRT1-ID16TAH Datasheet - Page 95

• Manufacturer Part Number: CRT1-ID16TAH
• Description: 16 In NPN 3 Tier
• Manufacturer: Omron

Specifications of CRT1-ID16TAH

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Preparing Flat Connectors
1,2,3...
1,2,3...
■ Cutting the Cable
■ Attaching the Cable
■ Pressure-welding the Connector
Cut the cable perpendicular to the length.
To prevent short-circuits, cut the cable with a sharp blade, such as wire cut-
ters, and be sure that there are no whiskers on the wires.
1. As shown in the diagram below, place the cable so that the white line is in
2. Hold the cable so that it does not move and close the cover.
Use the DWT-A02 Pliers to pressure-weld the connector.
1. As shown below, align the center (see arrows) of the connector cover with
the direction of the side with the open cover, with the white line on the cable
facing upward.
the center of the pressure-welding block on the Pliers.
(Side with cover open)
Connector position reference surfaces
White line
From the left: red, white, blue, and black
Section 3-3
71