CRT1-ID16TAH Omron, CRT1-ID16TAH Datasheet - Page 451

• Manufacturer Part Number: CRT1-ID16TAH
• Description: 16 In NPN 3 Tier
• Manufacturer: Omron

Specifications of CRT1-ID16TAH

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

9-3-5
Input Section
Specifications
Bit Slave Units with e-CON Connectors
Four-point Input Units (IP54)
CRT1B-ID04SP/CRT1B-ID04SP-1
Model
I/O capacity
Internal I/O common
ON voltage
OFF voltage
OFF current
Input current
Sensor power supply voltage
ON delay
OFF delay
Number of circuits per common
Power short-circuit detection
Isolation method
Input indicators
Degree of protection
Installation
Power supply type
Communications power supply
current consumption (See note.)
Input device supply current
Weight
Item
Note The current consumption is for Bit Slave Unit communications cur-
rent when all inputs are OFF, i.e., it does not include input device
current consumption. The communications power supply is also
used for the I/O power supply for sensors. Be sure to consider the
sensor current consumption and the number of sensors connected
in addition to the communications power. The power supply current
consumption is expressed by the following formula.
Communications power supply current consumption = Bit Slave
Unit communications current consumption + (Bit Slave Unit input
current × number of inputs used) + (sensor current consumption ×
number of sensors used)
4 inputs
NPN
10.5 VDC min. (between each
input terminal and the V terminal)
5 VDC max. (between each input
terminal and the V terminal)
1.0 mA max.
3.0 mA min./input (at 10.5 VDC)
Communications power supply voltage 0 V (max.)
Communications power supply voltage −1 V (min.)
1.5 ms max.
1.5 ms max.
4 inputs/common
Supported.
No isolation
LEDs (yellow)
IEC standard IP54
Screw installation (M4)
Network power supply
85 mA max. for 24-VDC power supply voltage
90 mA max. for 14-VDC power supply voltage
80 mA/2 points
188 g
CRT1B-ID04SP
Specification
PNP
10.5 VDC min. (between each
input terminal and the G terminal)
5 VDC max. (between each input
terminal and the G terminal)
CRT1B-ID04SP-1
Section 9-3
427