CRT1-ID16TAH Omron, CRT1-ID16TAH Datasheet - Page 610

• Manufacturer Part Number: CRT1-ID16TAH
• Description: 16 In NPN 3 Tier
• Manufacturer: Omron

Specifications of CRT1-ID16TAH

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Troubleshooting
586
Analog I/O Slave
Units and Tempera-
ture Input Units
Model
• The analog data values are
• A disconnection is detected
Cannot set using external
switches.
The user adjustment and bias
compensation settings are not
accepted for the CRT1-TS04T.
The Top/Valley Detection Tim-
ing Flag will not go ON.
The Top/Valley Count Over
Flag will not go ON (Tempera-
ture Input Units only).
The Top/Valley Detection Tim-
ing Flags go ON too frequently.
The top/valley count is unex-
pectedly high for a Tempera-
ture Input Unit.
different from expected or the
analog data error is too large.
even though it is not discon-
nected.
Problem
• The I/O data function alloca-
• The scaling function is oper-
• The connected Sensor is dif-
• The user adjustment error is
The following conditions apply
to Temperature Input Units
only.
• The setting for the 1/100 Dis-
• The sensor's decimal point
The following conditions apply
to the CRT1-TS04T only.
• The Unit is mounted vertically
• The Unit was replaced, but
• SW8 is turned OFF (default).
• Attempted to calibrate with
The hysteresis setting is too
high.
The hysteresis setting is 0.
The hysteresis setting is too
low.
tions are not correct.
ating.
ferent from the set input type.
too large.
play Mode/Normal Display
Mode is incorrect.
position was read incorrectly.
or face-down.
the terminal block was not
changed. (The accuracy may
be reduced if the components
are not replaced as a set.)
inputs outside the setting
range.
Cause
• Check again that the analog
• If using the Scaling function,
• Remove the Scaling function
• Check the input type again.
• Execute user adjustment
The following conditions apply
to Temperature Input Units
only.
• In Normal Display Mode, the
• In 1/100 Display Mode, the
• Check the Unit's mounting
• Turn ON SW 8.
• Calibrate again with the cor-
• Change the adjustment sys-
Adjust the hysteresis setting.
data type to be set is correctly
allocated for the I/O data.
check again that the scaling
value is correct.
if it has been allocated by
mistake.
again.
display value is multiplied by
x1 or x10, depending on the
input type setting.
display value is multiplied by
x100, regardless of the input
type setting. Check the set-
tings and input type again.
direction.
rect input voltage (current).
tem if necessary.
Possible correction
Section 12-2