CRT1-ID16TAH Omron, CRT1-ID16TAH Datasheet - Page 101

• Manufacturer Part Number: CRT1-ID16TAH
• Description: 16 In NPN 3 Tier
• Manufacturer: Omron

Specifications of CRT1-ID16TAH

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

3-4-2
T-branches
Using Round Cable I/II
Using Flat Cable I
Connecting Cables and Terminating Resistor
Branching Communications Cables
Note
■
Installation Method
There are two methods that can be used to branch the trunk line, sub-trunk
lines, and branch lines: T-branches and multidrop connections.
Connect the cable wires by using a commercially available relay terminal
block.
Example: Round cable I
Before connecting the cable wires to the terminal block, first attach the M3
crimp terminals shown below to the wires.
Attach a DCN4-BR4 Flat Connector Plug to the DCN4-TR4 Flat Connector
Socket connected to Communications Cable.
Be sure the surface of the Flat Connector Plug on which line colors are indi-
cated (red, white, black, and blue) is facing downward and press in the Con-
nector until it clicks into place.
6.0 mm max.
Flat Connector Socket
Note To remove a Connector once it has been attached, press in on the
Slave Unit
latches on both sides of the Connector and pull it out.
Flat Connector Plug
Relay terminal block
6.0 mm max.
Slave Unit
Section 3-4
77