MC56F8366MFVE Freescale Semiconductor, MC56F8366MFVE Datasheet - Page 35

• Manufacturer Part Number: MC56F8366MFVE
• Description: IC DSP 16BIT 60MHZ 144-LQFP
• Manufacturer: Freescale Semiconductor
• Series: 56F8xxxr

Specifications of MC56F8366MFVE

• Core Processor: 56800
• Core Size: 16-Bit
• Speed: 60MHz
• Connectivity: CAN, EBI/EMI, SCI, SPI
• Peripherals: POR, PWM, Temp Sensor, WDT
• Number Of I /o: 62
• Program Memory Size: 544KB (272K x 16)
• Program Memory Type: FLASH
• Ram Size: 18K x 16
• Voltage - Supply (vcc/vdd): 2.25 V ~ 3.6 V
• Data Converters: A/D 16x12b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 144-LQFP
• For Use With: MC56F8367EVME - EVAL BOARD FOR MC56F83X
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Freescale Semiconductor
Preliminary
TEMP_SENSE
Signal Name
(GPIOE8)
CAN_RX
CAN_TX
ANB0
ANB1
ANB2
ANB3
ANB4
ANB5
ANB6
ANB7
TC0
Table 2-2 Signal and Package Information for the 144-Pin LQFP
Pin No.
104
105
106
107
108
109
110
111
127
126
118
96
Schmitt
Schmitt
Schmitt
Output
Output
Output
Outpu
Open
Input/
Input/
Type
Drain
Input
Input
Input
enabled
enabled
During
Analog
Analog
Analog
Output
pull-up
Output
pull-up
Reset
Input,
Input,
State
Open
Drain
56F8366 Technical Data, Rev. 7
Input
Input
ANB0 - 3 — Analog inputs to ADC B, channel 0
ANB4 - 7 — Analog inputs to ADC B, channel 1
Temperature Sense Diode — This signal connects to an on-chip
diode that can be connected to one of the ADC inputs and used to
monitor the temperature of the die. Must be bypassed with a
0.01μF capacitor.
FlexCAN Receive Data — This is the CAN input. This pin has an
internal pull-up resistor.
To deactivate the internal pull-up resistor, set the CAN bit in the
SIM_PUDR register.
FlexCAN Transmit Data — CAN output with internal pull-up
enable at reset. *
* Note: If a pin is configured as open drain output mode, internal
pull-up will automatically be disabled when it outputs low. Internal
pull-up will be enabled unless it has been manually disabled by
clearing the corresponding bit in the PUREN register of the GPIO
module, when it outputs high.
If a pin is configured as push-pull output mode, internal pull-up will
automatically be disabled, whether it outputs low or high.
TC0 — Timer C, Channel 0
Port E GPIO — These GPIO pin can be individually programmed
as an input or output pin.
At reset, this pin defaults to timer functionality.
To deactivate the internal pull-up resistor, clear bit 8 of the
GPIOE_PUR register.
Signal Description
Signal Pins
35