HD64F3672FXV Renesas Electronics America, HD64F3672FXV Datasheet - Page 74

• Manufacturer Part Number: HD64F3672FXV
• Description: IC H8/3672 MCU FLASH 48LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of HD64F3672FXV

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: SCI
• Peripherals: PWM, WDT
• Number Of I /o: 26
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 48-LQFP
• For Use With: R0K436079S000BE - KIT DEV FOR H8/36079 W/COMPILER
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 3 Exception Handling
3.3
When the RES pin goes low, all processing halts and this LSI enters the reset. The internal state of
the CPU and the registers of the on-chip peripheral modules are initialized by the reset. To ensure
that this LSI is reset at power-up, hold the RES pin low until the clock pulse generator output
stabilizes. To reset the chip during operation, hold the RES pin low for at least 10 system clock
cycles. When the RES pin goes high after being held low for the necessary time, this LSI starts
reset exception handling. The reset exception handling sequence is shown in figure 3.1. The reset
exception handling sequence is as follows
1. Set the I bit in the condition code register (CCR) to 1.
2. The CPU generates a reset exception handling vector address (from H'0000 to H'0001), the
3.4
3.4.1
There are external interrupts, NMI, IRQ3, IRQ0, and WKP.
NMI
IRQ3 to IRQ0 Interrupts
Rev.4.00 Nov. 02, 2005 Page 48 of 304
REJ09B0143-0400
data in that address is sent to the program counter (PC) as the start address, and program
execution starts from that address.
NMI interrupt is requested by input falling edge to pin NMI.
NMI is the highest interrupt, and can always be accepted without depending on the I bit value
in CCR.
IRQ3 to IRQ0 interrupts are requested by input signals to pins IRQ3 to IRQ0. These four
interrupts are given different vector addresses, and are detected individually by either rising
edge sensing or falling edge sensing, depending on the settings of bits IEG3 to IEG0 in IEGR1.
When pins IRQ3 to IRQ0 are designated for interrupt input in PMR1 and the designated signal
edge is input, the corresponding bit in IRR1 is set to 1, requesting the CPU of an interrupt.
When IRQ3 to IRQ0 interrupt is accepted, the I bit is set to 1 in CCR. These interrupts can be
masked by setting bits IEN3 to IEN0 in IENR1.
Reset Exception Handling
Interrupt Exception Handling
External Interrupts