XC68HC705JJ7 Motorola, XC68HC705JJ7 Datasheet - Page 140

• Manufacturer Part Number: XC68HC705JJ7
• Description: MICROCONTROLLER
• Manufacturer: Motorola

Analog Subsystem
8.15 Noise Sensitivity
Advance Information
140
error due to the analog source output impedance. Since this may not
always be true, it is therefore best to disable port B pulldowns on those
pins used for analog input sources.
In addition to the normal effects of electrical noise on the analog input
signal there can also be other noise-related effects caused by the
digital-to-analog interface. Since there is only one V
digital and the analog subsystems on the device, currents in the digital
section may affect the analog ground reference within the device. This
can add voltage offsets to measured inputs or cause channel-to-channel
crosstalk.
To reduce the impact of these effects, there should be no switching of
heavy I/O currents to or from the device while there is a critical analog
conversion or voltage comparison in process. Limiting switched I/O
currents to 2–4 mA during these times is recommended.
A noise reduction benefit can be gained with 0.1- F bypass capacitors
from each analog input (PB4:1) to the V
digital power supply or load currents from passing through any
conductors which are the return paths for an analog signal.
Analog Subsystem
MC68HC705JJ7 • MC68HC705JP7 — REV 4
SS
pin. Also, try to keep all the
SS
return for both the
MOTOROLA