TMPM364F10FG Toshiba, TMPM364F10FG Datasheet - Page 105

• Manufacturer Part Number: TMPM364F10FG
• Manufacturer: Toshiba

Specifications of TMPM364F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 144
• Package: LQFP(20x20)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 5
• Uart/sio (ch): 12
• Usb: Host
• Can: 1
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: 16
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

(3)
(4)
(5)
(6)
set Control Register.
be used as the function pin. Setting PxIE[m] allows the pin to be used as the input port.
eral function for details.
bit of this register.
and enable interrupts in the CGIMCG register of the clock generator. The CGIMCG register is capa-
ble of configuring each source.
avoid unexpected interrupt.To clear corresponding interrupt request, write a value corresponding to
the interrupt to be used to the CGICRCG register.See "7.6.3.7 CGICRCG (CG Interrupt Request
Clear Register)" for each value.
NVIC register
<PRI_n>
<PRIGROUP>
Port register
PxFRn<PxmFn>
PxIE<PxmIE>
NVIC register
Interrupt Set-Pending [m]
You can assign grouping priority by using the <PRIGROUP> in the Application Interrupt and Re-
Set "1" to the port function register of the corresponding pin. Setting PxFRn[m] allows the pin to
The setting varies depending on the peripheral function to be used. See the chapter of each periph-
To generate an interrupt by using the Interrupt Set-Pending Register, set "1" to the corresponding
For an interrupt source to be used for exiting a standby mode, you need to set the active level
Before enabling an interrupt, clear the corresponding interrupt request already held. This can
Note:"n" indicates the corresponding exceptions/interrupts.
Note:x: port number / m: corresponding bit / n: function register number In modes other than
Note:m: corresponding bit
Preconfiguration (1) (Interrupt from external pin)
Preconfiguration (2) (Interrupt from peripheral function)
Preconfiguration (3) (Interrupt Set-Pending Register)
Configuring the clock generator
This product uses three bits for assigning a priority level.
STOP mode, setting PxIE to enable input enables the corresponding interrupt input regard-
less of the PxFR setting. Be careful not to enable interrupts that are not used. Also, be
aware of the description of "7.5.1.4 Precautions when using external interrupt pins".
←
←
←
←
←
"prioryty"
"group priority" (This is configurable if required.)
"1"
"1"
"1"
Page 79
TMPM364F10FG