CV500BSC51 Omron, CV500BSC51 Datasheet - Page 34

• Manufacturer Part Number: CV500BSC51
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500BSC51

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

3-3-2
3-3-3
3-3-4
Wiring the Cables
Star Configuration
Recommended Cables
Connecting the Cables
1,2,3...
Note
Note Up to two GP-IB Cable Connectors can be connected at the GP-IB Interface
It is also possible to combine daisy-chain and star configurations in the same
system.
Unit. In addition, the following restrictions apply to cable lengths in the system:
All three of these conditions must be satisfied simultaneously.
Use the following procedure to connect the cables.
1. Insert the cable connector into the GP-IB Interface Unit’s connector.
2. Tighten the connector attachment screws.
1. Turn OFF the PLC and the other devices in the system before connecting
2. There is a protective label on the top of the GP-IB Interface Unit. Leave this
3. After wiring the Unit, remove the protective label to allow air circulation
4. Always tighten the connector attachment screws. Tighten the screws to a
5. Double check the wiring before turning ON the power.
6. Observe the following precautions when wiring.
7. Before handling the Unit, touch a grounded metal object to discharge any
GP-IB Harness
Device
• Total cable length: 20 m max.
• Total cable length: Number of devices
• Single cable length: 4 m max. (when connecting 1:1)
or disconnecting cables.
label attached during wiring and installation procedures.
needed for cooling.
torque of 0.6 N m.
static electricity.
• Keep the communications cables away from power lines and high-volt-
• Do not bend the cable sharply.
• Do not pull on the cable.
• Do not place objects on top of the cables.
• Always route the cables within ducts.
age lines.
Name
Device
408JE-101
408JE-102
408JE-104
408JE-10P5
Device
Model
Device
0.5 m
1 m
2 m
4 m
2 m max.
Length
DDK Electronics,
Inc.
Manufacturer
Section 3-3
17