CV500BSC51 Omron, CV500BSC51 Datasheet - Page 33

• Manufacturer Part Number: CV500BSC51
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500BSC51

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Mounting the Unit in the PLC
3-2
3-3
3-3-1
16
Mounting the Unit in the PLC
Wiring the Cables
Daisy-chain Configuration
Note
Note If the GP-IB Interface Unit is mounted in a CS-series Expansion Backplane,
The GP-IB Interface Unit must be mounted in the PLC (CPU Backplane or
Expansion Backplane) to be used. Refer to the CS Series Programmable
Controllers Operation Manual for details on installing the Unit in the Back-
plane.
1. Always turn OFF the PLC before mounting the Unit.
2. Tighten the PLC’s Backplane mounting screws to a torque of 0.9 N m and
3. The GP-IB Interface Unit has a protective label on the top of the Unit that
4. After the Unit has been mounted and wiring has been completed, remove
5. If other CS-series Special I/O Units are being mounted, the total number
the GP-IB Interface Unit cannot start an external interrupt task in the specified
CPU Unit when the Interface Unit receives an SRQ message from a Talker or
Listener. Mount the GP-IB Interface Unit in the CPU Backplane if it is neces-
sary to start an external interrupt task in the CPU Unit after receiving an SRQ
message.
Use GP-IB Cable to connect the GP-IB devices in a daisy-chain configuration
or star configuration.
CS-series Expansion Backplane
CS1W-BI@@@
C200H Expansion I/O Backplane
CPU Backplane
CS1W-BC@@@
Device
tighten the Unit fastening screw to a torque of 0.4 N m.
label prevents wire strands and other foreign matter from entering the Unit.
Leave this label attached during wiring and installation procedures.
the protective label to allow air circulation needed for cooling.
2, 3, 5, 8, or 10 slots
of CS-series Special I/O Units in a single PLC must not exceed 96 Units.
3, 5, 8, or 10 slots
Device
C
P
U
P
S
P
S
P
S
CS-series Expansion Rack
Mount the Unit in any of the leftmost
3, 5, 8, or 10 slots.
C200H Expansion I/O Rack
The Unit cannot be mounted in
any slot.
CPU Rack
Mount the Unit in any of the leftmost
2, 3, 5, 8, or 10 slots.
Device
Device
Note:
PS = Power Supply Unit
CPU = CPU Unit
Mount Units in
up to 4 slots.
Section 3-2