5.07.01 FLASHER ARM Segger Microcontroller Systems, 5.07.01 FLASHER ARM Datasheet - Page 19

• Manufacturer Part Number: 5.07.01 FLASHER ARM
• Description: PROGRAMMER JTAG FOR ARM CORES
• Manufacturer: Segger Microcontroller Systems
• Type: In-System Programmerr

Specifications of 5.07.01 FLASHER ARM

• Contents: Programmer
• For Use With/related Products: ARM7, ARM9, Cortex
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 899-1002

2.2
Flasher ARM (UM08007)
It is also possible to have multiple data files and config files on Flasher ARM, to make
Flasher ARM more easy to use in production environment. To choose the correct con-
figuration file and data file pair, a FLASHER.INI file is used. This init file contains a
[FILES] section which describes which configuration file and which data file should
be used for programming. A sample content of a FLASHER.INI file is shown below:
[FILES]
DataFile = "Flasher1.dat"
ConfigFile = "Flasher1.cfg"
Using this method all configuration files and data files which are used in the produc-
tion only have to be downloaded once. From there on a configuration file / data file
pair can be switched by simply replacing the FLASHER.INI by a new one, which con-
tains the new descriptions for the configuration file and data file. The FLASHER.INI
can be replaced in two ways:
1.
2.
Multiple File Support
Boot Flasher ARM in MSD mode in order to replace the FLASHER.INI
If Flasher ARM is already integrated into the production line, runs in stand-alone
mode and can not be booted in other mode: Use the file I/O commands provided
by the ASCII interface of Flasher ARM, to replace the FLASHER.INI. For more
information about the file I/O commands, please refer to File I/O commands on
page 34.
© 2004-2009 SEGGER Microcontroller GmbH & Co. KG
19