upd78f0114m6gb-8es Renesas Electronics Corporation., upd78f0114m6gb-8es Datasheet - Page 338

• Manufacturer Part Number: upd78f0114m6gb-8es
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: Renesas Electronics Corporation.

(2) STOP mode
set are held. The I/O port output latches and output buffer statuses are also held.
17.1.2 Registers controlling standby function
338
In either of these two modes, all the contents of registers, flags and data memory just before the standby mode is
Cautions 1. STOP mode can be used only when CPU is operating on the X1 input clock or Ring-OSC
The standby function is controlled by the following two registers.
• Oscillation stabilization time counter status register (OSTC)
• Oscillation stabilization time select register (OSTS)
Remark For the registers that start, stop, or select the clock, see CHAPTER 5 CLOCK GENERATOR.
STOP instruction execution sets the STOP mode. In the STOP mode, the X1 oscillator stops, stopping the whole
system, thereby considerably reducing the CPU operating current.
Because this mode can be released by an interrupt request, it enables intermittent operations to be carried out.
However, because a wait time is required to secure the oscillation stabilization time after the STOP mode is
released, select the HALT mode if it is necessary to start processing immediately upon interrupt request
generation.
2. When shifting to the STOP mode, be sure to stop the peripheral hardware operation before
3. The following sequence is recommended for operating current reduction of the A/D converter
4. If the Ring-OSC oscillator is operating before the STOP mode is set, oscillation of the Ring-
clock. HALT mode can be used when CPU is operating on the X1 input clock, Ring-OSC
clock, or subsystem clock. However, when the STOP instruction is executed during Ring-
OSC clock operation, the X1 oscillator stops, but Ring-OSC oscillator does not stop.
executing STOP instruction.
when the standby function is used: First clear bit 7 (ADCS) of the A/D converter mode
register (ADM) to 0 to stop the A/D conversion operation, and then execute the HALT or STOP
instruction.
OSC clock cannot be stopped in the STOP mode. However, when the Ring-OSC clock is used
as the CPU clock, the CPU operation is stopped for 17/f
CHAPTER 17 STANDBY FUNCTION
User’s Manual U16227EJ3V0UD
R
(s) after STOP mode is released.