EPC16xxx Altera, EPC16xxx Datasheet - Page 2

• Manufacturer Part Number: EPC16xxx
• Description: (EPC4 / EPC8 / EPC16) Enhanced Configuration Devices
• Manufacturer: Altera

Functional Description
Functional
Description
2–2
Configuration Handbook, Volume 2
f
■
■
■
■
■
■
■
■
For more information on FPGA configuration schemes and advanced
features, refer to the appropriate FPGA family chapter in the
Configuration Handbook.
The Altera enhanced configuration device is a single-device, high-speed,
advanced configuration solution for very high-density FPGAs. The core
of an enhanced configuration device is divided into two major blocks, a
configuration controller and a flash memory. The flash memory is used to
store configuration data for systems made up of one or more Altera
FPGAs. Unused portions of the flash memory can be used to store
processor code or data that can be accessed via the external flash interface
after FPGA configuration is complete.
1
The enhanced configuration device has a 3.3-V core and I/O interface.
The controller chip is a synchronous system that implements the various
interfaces and features.
enhanced configuration device. The controller chip features three
separate interfaces:
■
■
■
Hardware compliant with IEEE Std. 1532 in-system
programmability (ISP) specification
Supports ISP via Jam Standard Test and Programming Language
(STAPL)
Supports Joint Test Action Group (JTAG) boundary scan
nINIT_CONF pin allows private JTAG instruction to initiate FPGA
configuration
Internal pull-up resistor on nINIT_CONF always enabled
User programmable weak internal pull-up resistors on nCS and OE
pins
Internal weak pull-up resistors on external flash interface address
and control lines, bus hold on data lines
Standby mode with reduced power consumption
A configuration interface between the controller and the Altera
FPGA(s)
A JTAG interface on the controller that enables in-system
programmability (ISP) of the flash memory
An external flash interface that the controller shares with an external
processor, or FPGA implementing a Nios
(interface available after ISP and configuration)
The external flash interface is currently supported in the EPC16
and EPC4 devices. For information on using this feature in the
EPC8 device, contact Altera Applications.
Figure 2–1
shows a block diagram of the
®
embedded processor
Altera Corporation
August 2005