ST72325R6-AUTO STMicroelectronics, ST72325R6-AUTO Datasheet - Page 22

• Manufacturer Part Number: ST72325R6-AUTO
• Description: 8-bit Mcu For Automotive With 16 To 60 Kbyte Flash, Adc, Css, 5 Timers, Spi, Sci, I2c Interface
• Manufacturer: STMicroelectronics

Introduction
22/250
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
–
–
–
Figure 1: Device block diagram on page
–
–
–
Chapter 2: Package pinout and pin description on page
–
–
Figure 4: 32-pin LQFP package pinout on page
Table 2: Device pin descriptions (LQFP64 and LQFP44) on page
–
–
–
–
–
–
Table 3: Device pin descriptions (LQFP32) on page
–
–
–
–
–
Section 4.3.1: Readout protection on page
Figure 3: 44-pin LQFP package pinout on page
and 6 to those in
Section 4.6: IAP (in-application programming) on page
and CAN interfaces in second paragraph
Section 9.3: I/O port implementation on page
–
–
–
–
–
Table 31: I/O port configuration on page
–
–
Table 104: Voltage characteristics on page
as
Section 17.3.2: Starting the conversion on page
resets the EOC bit’ with ‘A read to the ADCDRH or a write to any bit of the ADCCSR
Note 2
transferred from cover page to
updated to include only automotive devices
removed ROM from program memory column
added R devices to bit counts for ports F, E, D, C, B and A
removed C devices from bit counts for ports F, E, D, B and A
modified
48-pin LQFP pinout
32-pin DIP and 42-pin DIP pinouts
removed LQFP48 and SDIP42 devices
reorganized footnotes
removed ‘High voltage must not be applied to ROM devices’ from V
removed footnote link from PA6 and PA7 alternate functions cells
linked
defined pin EVD as type ‘I’ and as input level ‘A’
removed DIP32 device
reorganized footnotes
removed ‘High voltage must not be applied to ROM devices’ from V
removed footnote link from PA6 and PA7 alternate functions cells
removed footnote concerning pads that are not bonded
Standard ports PA5:4, PC7:0, PD7:0, PE7:3, PE1:0, PF7:3
Interrupt ports PA2:0, PB6:5, PB4, PB2:0, PF1:0 (with pull-up)
Interrupt ports PA3, PB7, PB3, PF2 (without pull-up)
True open-drain ports PA7:6
Pull-up input port PE2
I/O port configuration on page
added DDR values to input and output column headers
modified
for
Note 1
Table
Note 1
Note 1
Table 2
to unbonded I/O pins in LQFP44 column
105)
(configurations of these five tables already exist in
83)
Section 1.1: Description
83:
19:
40: Removed references to ROM devices
195: Removed note 2 (this note exists only
83: Removed following five tables:
26: Aligned pin names for pins 2, 3, 4, 5
27: Removed DIP package
182: Replaced ‘A read to the ADCDRH
32:
42: Removed reference to USB
25: Removed following figures:
28:
ST72325xxx-Auto
PP
PP
function text
function text
Table 31: