ST72325R6-AUTO STMicroelectronics, ST72325R6-AUTO Datasheet - Page 196

• Manufacturer Part Number: ST72325R6-AUTO
• Description: 8-bit Mcu For Automotive With 16 To 60 Kbyte Flash, Adc, Css, 5 Timers, Spi, Sci, I2c Interface
• Manufacturer: STMicroelectronics

Electrical characteristics
19.2.2
19.2.3
196/227
Current characteristics
Table 105. Current characteristics
1. All power (V
2. I
3. Negative injection may disturb the analog performance of the device. See
4. When several inputs are submitted to a current injection, the maximum ΣI
5. True open-drain I/O port pins do not accept positive injection.
Thermal characteristics
Table 106. Thermal characteristics
Symbol
I
I
VDD
ΣI
INJ(PIN)
T
Symbol
cannot be respected, the injection current must be limited externally to the I
injection is induced by V
pads, there is no positive injection current, and the corresponding V
accuracy on page
positive and negative injected currents (instantaneous values). These results are based on
characterization with ΣI
INJ(PIN)
STG
T
INJ(PIN)
J
/ I
I
IO
VSS
(2)(3)
(2)
Storage temperature range
Maximum junction temperature (see
must never be exceeded. This is implicitly ensured if V
(1)
DD
Total current into V
(source) and V
Output current sunk by any standard I/O and control pin
Output current sunk by any high sink I/O pin
Output current source by any I/Os and control pin
Injected current on V
Injected current on RESET pin
Injected current on OSC1 and OSC2 pins
Injected current on PB0 pin
Injected current on any other pin
Total injected current (sum of all I/O and control pins)
) and ground (V
227.
INJ(PIN)
IN
> V
SS
DD
SS
maximum current injection on four I/O port pins of the device.
) lines must always be connected to the external supply.
while a negative injection is induced by V
Ratings
ground lines (sink)
DD
PP
power lines
pin
Ratings
Section 20.2: Thermal characteristics on page
(4)(5)
32-pin devices
44-/64-pin devices
IN
maximum is respected. If V
IN
maximum must always be respected.
INJ(PIN)
(4)
Note 1
IN
INJ(PIN)
-65 to +150
< V
is the absolute sum of the
Value
SS
in
value. A positive
. For true open-drain
Maximum value Unit
Table 137: ADC
ST72325xxx-Auto
± 25
- 25
150
± 5
± 5
± 5
+ 5
± 5
75
20
40
IN
maximum
Unit
232)
°C
mA
mA