LAN9303-ABZJ Standard Microsystems (SMSC), LAN9303-ABZJ Datasheet - Page 209

• Manufacturer Part Number: LAN9303-ABZJ
• Manufacturer: Standard Microsystems (SMSC)

Specifications of LAN9303-ABZJ

• Number Of Primary Switch Ports: 3
• Operating Supply Voltage (typ): 3.3V
• Fiber Support: No
• Power Supply Type: Analog
• Data Rate (typ): 10/100Mbps
• Vlan Support: Yes
• Operating Temperature (max): 70C
• Operating Temperature (min): 0C
• Mounting: Surface Mount
• Jtag Support: No
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• Operating Temperature Classification: Commercial
• Data Rate: 100Mbps
• Lead Free Status / RoHS Status: Compliant

Small Form Factor Three Port 10/100 Managed Ethernet Switch with Single MII/RMII/Turbo MII
Datasheet
SMSC LAN9303/LAN9303i
13.3.2.11
BITS
15:8
7
6
5
4
3
2
1
0
RESERVED
INT7
This interrupt source bit indicates when the
the
(PHY_MODE_CONTROL_STATUS_x)
0: Not source of interrupt
1: ENERGYON generated
INT6
This interrupt source bit indicates Auto-Negotiation is complete.
0: Not source of interrupt
1: Auto-Negotiation complete
INT5
This interrupt source bit indicates a remote fault has been detected.
0: Not source of interrupt
1: Remote fault detected
INT4
This interrupt source bit indicates a Link Down (link status negated).
0: Not source of interrupt
1: Link Down (link status negated)
INT3
This interrupt source bit indicates an Auto-Negotiation LP acknowledge.
0: Not source of interrupt
1: Auto-Negotiation LP acknowledge
INT2
This interrupt source bit indicates a Parallel Detection fault.
0: Not source of interrupt
1: Parallel Detection fault
INT1
This interrupt source bit indicates an Auto-Negotiation page received.
0: Not source of interrupt
1: Auto-Negotiation page received
RESERVED
Port x PHY Interrupt Source Flags Register (PHY_INTERRUPT_SOURCE_x)
This read-only register is used to determine to source of various Port x PHY interrupts. All interrupt
source bits in this register are read-only and latch high upon detection of the corresponding interrupt
(if enabled). A read of this register clears the interrupts. These interrupts are enabled or masked via
the
Port x PHY Mode Control/Status Register
Port x PHY Interrupt Mask Register
Index (decimal): 29
DESCRIPTION
DATASHEET
has been set.
(PHY_INTERRUPT_MASK_x).
Energy On (ENERGYON)
209
Size:
16 bits
bit of
RO/LH
RO/LH
RO/LH
RO/LH
RO/LH
RO/LH
RO/LH
TYPE
RO
RO
Revision 1.4 (07-07-10)
DEFAULT
0b
0b
0b
0b
0b
0b
0b
-
-