DF2148BTE20 Renesas Electronics America, DF2148BTE20 Datasheet - Page 209

• Manufacturer Part Number: DF2148BTE20
• Description: IC H8S MCU FLASH 128K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2148BTE20

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: I²C, IrDA, SCI, X-Bus
• Peripherals: PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2148BTE20; HD64F2148BTE20

7.4
Locate the register information in the on-chip RAM (addresses: H'(FF)EC00 to H'(FF)EFFF).
Register information should be located at an address that is a multiple of four within the range.
The method for locating the register information in address space is shown in figure 7.3. Locate
MRA, SAR, MRB, DAR, CRA, and CRB, in that order, from the start address of the register
information. In the case of chain transfer, register information should be located in consecutive
areas as shown in figure 7.3, and the register information start address should be located at the
vector address corresponding to the interrupt source in the DTC vector table. The DTC reads the
start address of the register information from the vector table set for each activation source, and
then reads the register information from that start address.
When the DTC is activated by software, the vector address is obtained from: H'0400 +
(DTVECR[6:0]
The configuration of the vector address is the same in both normal and advanced modes; a 2-byte
unit is used in both cases. Specify the lower two bits of the register information start address.
Register
information
start address
Chain
transfer
Location of Register Information and DTC Vector Table
Figure 7.3 DTC Register Information Location in Address Space
2). For example, if DTVECR is H'10, the vector address is H'0420.
MRA
MRA
MRB
MRB
0
CRA
CRA
Lower address
1
4 bytes
DAR
DAR
SAR
SAR
2
CRB
CRB
Section 7 Data Transfer Controller (DTC)
Rev. 3.00 Mar 21, 2006 page 153 of 788
3
Register information
Register information
for 2nd transfer in
chain transfer
REJ09B0300-0300