mpc5632m Freescale Semiconductor, Inc, mpc5632m Datasheet - Page 50

• Manufacturer Part Number: mpc5632m
• Description: Mpc5634m Microcontroller Data Sheet
• Manufacturer: Freescale Semiconductor, Inc

22
23
24
25
26
27
28
29
30
31
32
33
34
35
From the user point of view this is an output pad; to implement the CAN protocol this pad must also implement the input direction.
The function and state of the CAN_A and eSCI_A pins after execution of the BAM program is determined by the BOOTCFG1 pin.
eTPU_A[25] is an output only function.
Only the output channels of eTPU[8:9] are connected to pins.
Only the output of eMIOS[12] is connected to the pin. The DSPI_C_SOUT is not available in this device.
The function after reset of the XTAL pin is determined by the value of the signal on the PLLCFG[1] pin. When bypass mode is chosen XTAL has no function and should be
grounded.
The function after reset of the EXTAL_EXTCLK pin is determined by the value of the signal on the PLLCFG[1] pin. If the EXTCLK function is chosen, the valid operating voltage
for the pin is 1.62 V to 3.6 V. If the EXTAL function is chosen, the valid operating voltage is 3.3 V.
VSSPLL and VSSREG are connected to the same pin.
This pin is shared by two pads: VDDA_AN, using pad_vdde_hv, and VDDA_DIG, using pad_vdde_int_hv.
This pin is shared by two pads: VSSA_AN, using pad_vsse_hv, and VSSA_DIG, using pad_vsse_int_hv.
VDDE12/VSSE12 pins are to be used for decoupling capacitors only.
LVDS pins will not work at 3.3 V.
The VDDEH6 segment may be powered from 3.0 V to 5.0 V for mux address or SSI functions, but must meet the VDDA specifications of 4.5 V to 5.25 V for analog input function.
If using JTAG or Nexus, the I/O segment that contains the JTAG and Nexus pins must be powered by a 5 V supply. The 3.3 V Nexus/JTAG signals are derived from the 5 volt
power supply.