EP1S20F780I6N Altera, EP1S20F780I6N Datasheet - Page 603

• Manufacturer Part Number: EP1S20F780I6N
• Description: IC STRATIX FPGA 20K LE 780-FBGA
• Manufacturer: Altera
• Series: Stratix®r

Specifications of EP1S20F780I6N

• Number Of Logic Elements/cells: 18460
• Number Of Labs/clbs: 1846
• Total Ram Bits: 1669248
• Number Of I /o: 586
• Voltage - Supply: 1.425 V ~ 1.575 V
• Mounting Type: Surface Mount
• Operating Temperature: -40°C ~ 100°C
• Package / Case: 780-FBGA
• Family Name: Stratix
• Number Of Logic Blocks/elements: 18460
• # I/os (max): 586
• Frequency (max): 450.05MHz
• Process Technology: 0.13um (CMOS)
• Operating Supply Voltage (typ): 1.5V
• Logic Cells: 18460
• Ram Bits: 1669248
• Operating Supply Voltage (min): 1.425V
• Operating Supply Voltage (max): 1.575V
• Operating Temp Range: -40C to 100C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 780
• Package Type: FC-FBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of Gates: -
• Lead Free Status / Rohs Status: Compliant

Altera Corporation
September 2004
Implementing High Performance DSP Functions in Stratix & Stratix GX Devices
Figure 7–14. Block Diagram Representation of Decimation
Decimation filters reverse the effect of the interpolation filters. Before the
decimation process, a low pass filter is applied to the signal to attenuate
noise and aliases present beyond the Nyquist frequency. The filtered
signal is then applied to the decimation filter, which processes every D-th
input. Therefore the values between samples D, D-1, D-2 etc. are ignored.
This allows the filter to run M times slower than the input data rate.
In a typical system, after the analog to digital conversion is complete, the
data needs to be filtered to remove aliases inherent in the sampled data.
Further, at this point there is no need to continue to process this data at
the higher sample (oversampled) rate. Therefore, a decimation FIR filter
at the output of the ADC lowers the data rate to a value that can be
processed digitally.
Figure 7–15
is decimated by a factor of 4 to 2 MHz. The Nyquist frequency of the
downsampled signal must be greater than 2 MHz, and is chosen to be
2.25 MHz in this example.
sample rate f s
shows a specific example where a signal spread over 8 MHz
Input
LPF
Stratix Device Handbook, Volume 2
D
Output
sample rate f s /D
7–25