M68EVB908GB60E Freescale Semiconductor, M68EVB908GB60E Datasheet - Page 183

• Manufacturer Part Number: M68EVB908GB60E
• Description: BOARD EVAL FOR MC9S08GB60
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of M68EVB908GB60E

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MC9S08GB
• Data Bus Width: 8 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: S08GB
• Kit Contents: GB60 Evaluation Kit
• Rohs Compliant: Yes
• For Use With/related Products: MC9S08GB60
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

OR — Receiver Overrun Flag
NF — Noise Flag
FE — Framing Error Flag
PF — Parity Error Flag
11.10.5 SCI x Status Register 2 (SCIxS2)
This register has one read-only status flag. Writes have no effect.
Freescale Semiconductor
OR is set when a new serial character is ready to be transferred to the receive data register (buffer), but
the previously received character has not been read from SCIxD yet. In this case, the new character
(and all associated error information) is lost because there is no room to move it into SCIxD. To clear
OR, read SCIxS1 with OR = 1 and then read the SCI data register (SCIxD).
The advanced sampling technique used in the receiver takes seven samples during the start bit and
three samples in each data bit and the stop bit. If any of these samples disagrees with the rest of the
samples within any bit time in the frame, the flag NF will be set at the same time as the flag RDRF gets
set for the character. To clear NF, read SCIxS1 and then read the SCI data register (SCIxD).
FE is set at the same time as RDRF when the receiver detects a logic 0 where the stop bit was expected.
This suggests the receiver was not properly aligned to a character frame. To clear FE, read SCIxS1
with FE = 1 and then read the SCI data register (SCIxD).
PF is set at the same time as RDRF when parity is enabled (PE = 1) and the parity bit in the received
character does not agree with the expected parity value. To clear PF, read SCIxS1 and then read the
SCI data register (SCIxD).
1 = Receive overrun (new SCI data lost).
0 = No overrun.
1 = Noise detected in the received character in SCIxD.
0 = No noise detected.
1 = Framing error.
0 = No framing error detected. This does not guarantee the framing is correct.
1 = Parity error.
0 = No parity error.
Reset:
Read:
Write:
Bit 7
Figure 11-10. SCI x Status Register 2 (SCIxS2)
0
0
= Unimplemented or Reserved
MC9S08GB/GT Data Sheet, Rev. 2.3
6
0
0
5
0
0
4
0
0
3
0
0
2
0
0
SCI Registers and Control Bits
1
0
0
Bit 0
RAF
0
183