LPC1313FHN33/01,51 NXP Semiconductors, LPC1313FHN33/01,51 Datasheet - Page 19

• Manufacturer Part Number: LPC1313FHN33/01,51
• Description: ARM Microcontrollers - MCU CortexM3 32bit 32KB
• Manufacturer: NXP Semiconductors

Specifications of LPC1313FHN33/01,51

• Rohs: yes
• Core: ARM Cortex M3
• Processor Series: LPC1313
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 72 MHz
• Program Memory Size: 32 KB
• Data Ram Size: 8 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 2 V to 3.6 V
• Package / Case: HVQFN-33
• Mounting Style: SMD/SMT
• Factory Pack Quantity: 4000

NXP Semiconductors
LPC1311_13_42_43
Product data sheet
7.6.1 Features
7.6.2 Interrupt sources
7.8.1 Features
7.7 IOCONFIG block
7.8 Fast general purpose parallel I/O
Each peripheral device has one interrupt line connected to the NVIC but may have several
interrupt flags. Individual interrupt flags may also represent more than one interrupt
source.
Any GPIO pin (total of up to 42 pins) regardless of the selected function, can be
programmed to generate an interrupt on a level, or rising edge or falling edge, or both.
The IOCONFIG block allows selected pins of the microcontroller to have more than one
function. Configuration registers control the multiplexers to allow connection between the
pin and the on-chip peripherals.
Peripherals should be connected to the appropriate pins prior to being activated and prior
to any related interrupt(s) being enabled. Activity of any enabled peripheral function that is
not mapped to a related pin should be considered undefined.
Device pins that are not connected to a specific peripheral function are controlled by the
GPIO registers. Pins may be dynamically configured as inputs or outputs. Multiple outputs
can be set or cleared in one write operation.
LPC1311/13/42/43 use accelerated GPIO functions:
Additionally, any GPIO pin (total of up to 42 pins) providing a digital function can be
programmed to generate an interrupt on a level, a rising or falling edge, or both.
•
•
•
•
•
•
•
•
•
•
•
Controls system exceptions and peripheral interrupts.
On the LPC1311/13/42/43, the NVIC supports up to 17 vectored interrupts. In
addition, up to 40 of the individual GPIO inputs are NVIC-vector capable.
8 programmable interrupt priority levels, with hardware priority level masking
Relocatable vector table.
Software interrupt generation.
GPIO block is a dedicated AHB peripheral so that the fastest possible I/O timing can
be achieved.
Entire port value can be written in one instruction.
Bit level port registers allow a single instruction to set or clear any number of bits in
one write operation.
Direction control of individual bits.
All I/O default to inputs with pull-up resistors enabled after reset with the exception of
the I
Pull-up/pull-down resistor configuration can be programmed through the IOCONFIG
block for each GPIO pin.
2
C-bus pins PIO0_4 and PIO0_5.
All information provided in this document is subject to legal disclaimers.
Rev. 5 — 6 June 2012
32-bit ARM Cortex-M3 microcontroller
LPC1311/13/42/43
© NXP B.V. 2012. All rights reserved.
19 of 74