M45PE10-VMN6 STMICROELECTRONICS [STMicroelectronics], M45PE10-VMN6 Datasheet - Page 19

no-image

M45PE10-VMN6

Manufacturer Part Number
M45PE10-VMN6
Description
1 Mbit, Low Voltage, Page-Erasable Serial Flash Memory With Byte-Alterability and a 25 MHz SPI Bus Interface
Manufacturer
STMICROELECTRONICS [STMicroelectronics]
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
M45PE10-VMN6P
Manufacturer:
ST
0
Part Number:
M45PE10-VMN6P
Manufacturer:
ST
Quantity:
20 000
Part Number:
M45PE10-VMN6TP
Manufacturer:
ST
0
Part Number:
M45PE10-VMN6TP
Manufacturer:
ST
Quantity:
20 000
Company:
Part Number:
M45PE10-VMN6TP
Quantity:
2 265
Company:
Part Number:
M45PE10-VMN6TP
Quantity:
10
Sector Erase (SE)
The Sector Erase (SE) instruction sets to 1 (FFh)
all bits inside the chosen sector. Before it can be
accepted, a Write Enable (WREN) instruction
must previously have been executed. After the
Write Enable (WREN) instruction has been decod-
ed, the device sets the Write Enable Latch (WEL).
The Sector Erase (SE) instruction is entered by
driving Chip Select (S) Low, followed by the in-
struction code, and three address bytes on Serial
Data Input (D). Any address inside the Sector (see
Table
(SE) instruction. Chip Select (S) must be driven
Low for the entire duration of the sequence.
The instruction sequence is shown in
Chip Select (S) must be driven High after the
eighth bit of the last address byte has been latched
in, otherwise the Sector Erase (SE) instruction is
Figure 16. Sector Erase (SE) Instruction Sequence
Note: Address bits A23 to A17 are Don’t Care.
3.) is a valid address for the Sector Erase
S
C
D
0
1
2
Instruction
3
Figure
4
5
16..
6
7
MSB
23 22
8
not executed. As soon as Chip Select (S) is driven
High, the self-timed Sector Erase cycle (whose du-
ration is t
cle is in progress, the Status Register may be read
to check the value of the Write In Progress (WIP)
bit. The Write In Progress (WIP) bit is 1 during the
self-timed Sector Erase cycle, and is 0 when it is
completed. At some unspecified time before the
cycle is complete, the Write Enable Latch (WEL)
bit is reset.
A Sector Erase (SE) instruction applied to a sector
that contains a page that is Hardware Protected is
not executed.
Any Sector Erase (SE) instruction, while an Erase,
Program or Write cycle is in progress, is rejected
without having any effects on the cycle that is in
progress.
9
24 Bit Address
SE
2
29 30 31
) is initiated. While the Sector Erase cy-
1
0
AI03751D
M45PE10
19/34

Related parts for M45PE10-VMN6