LPC47N237-MD SMSC [SMSC Corporation], LPC47N237-MD Datasheet - Page 58

• Manufacturer Part Number: LPC47N237-MD
• Description: 3.3V I/O CONTROLLER FOR PORT REPLICATORS AND DOCKING STATIONS
• Manufacturer: SMSC [SMSC Corporation]

Revision 0.3 (10-26-04)
cnfgA (Configuration Register A)
ADDRESS OFFSET = 400H
Mode = 111
This register is a read only register. When read, 10H is returned. This indicates to the system that this is an
8-bit implementation. (PWord = 1 byte)
cnfgB (Configuration Register B)
ADDRESS OFFSET = 401H
Mode = 111
BIT 7 compress
This bit is read only. During a read it is a low level. This means that this chip does not support hardware RLE
compression. It does support hardware de-compression!
BIT 6 intrValue
Returns the value of the interrupt to determine possible conflicts.
BITS [5:3] Parallel Port IRQ (read-only)
Refer to Table 9.7.
BITS [2:0] Parallel Port DMA (read-only)
Refer to Table 9.8.
ecr (Extended Control Register)
ADDRESS OFFSET = 402H
Mode = all
This register controls the extended ECP parallel port functions.
BITS 7,6,5
These bits are Read/Write and select the Mode.
BIT 4 nErrIntrEn
Read/Write (Valid only in ECP Mode)
1:
0:
Disables the interrupt generated on the asserting edge of nFault.
Enables an interrupt pulse on the high to low edge of nFault. Note that an interrupt will be generated if
nFault is asserted (interrupting) and this bit is written from a 1 to a 0. This prevents interrupts from
being lost in the time between the read of the ecr and the write of the ecr.
DATASHEET
Page 58
3.3v I/O Controller for Port Replicators and Docking Stations
SMSC DS – LPC47N237