LPC47N237-MD SMSC [SMSC Corporation], LPC47N237-MD Datasheet - Page 55

• Manufacturer Part Number: LPC47N237-MD
• Description: 3.3V I/O CONTROLLER FOR PORT REPLICATORS AND DOCKING STATIONS
• Manufacturer: SMSC [SMSC Corporation]

3.3v I/O Controller for Port Replicators and Docking Stations
Note 9.8
SMSC DS – LPC47N237
Data And ecpAFifo Port
ADDRESS OFFSET = 00H
Modes 000 and 001 (Data Port)
The Data Port is located at an offset of '00H' from the base address. The data register is cleared at
initialization by RESET. During a WRITE operation, the Data Register latches the contents of the data
bus. The contents of this register are buffered (non inverting) and output onto the PD0 - PD7 ports.
During a READ operation, PD0 - PD7 ports are read and output to the host CPU.
Mode 011 (ECP FIFO - Address/RLE)
A data byte written to this address is placed in the FIFO and tagged as an ECP Address/RLE. The
hardware at the ECP port transmits this byte to the peripheral automatically. The operation of this register
is ony defined for the forward direction (direction is 0). Refer to the ECP Parallel Port Forward Timing
Diagram, located in the Timing Diagrams section of this data sheet .
Device Status Register (DSR)
ADDRESS OFFSET = 01H
The Status Port is located at an offset of '01H' from the base address. Bits 0 - 2 are not implemented as
register bits, during a read of the Printer Status Register these bits are a low level. The bits of the Status
Port are defined as follows:
BIT 3 nFault
The level on the nFault input is read by the CPU as bit 3 of the Device Status Register.
BIT 4 Select
The level on the Select input is read by the CPU as bit 4 of the Device Status Register.
BIT 5 PError
The level on the PError input is read by the CPU as bit 5 of the Device Status Register. Printer Status
Register.
Refer to ECR Register Description
MODE
000
001
010
011
100
101
110
111
SPP mode
PS/2 Parallel Port mode
Parallel Port Data FIFO mode
ECP Parallel Port mode
EPP mode (If this option is enabled in the configuration registers)
Reserved
Test mode
Configuration mode
Table 9.5 – Parallel Port Mode Description
DATASHEET
DESCRIPTION
Page 55
(NOTE 9.8)
Revision 0.3 (10-26-04)