lan91c100 Standard Microsystems Corp., lan91c100 Datasheet - Page 30

• Manufacturer Part Number: lan91c100
• Description: Feast ? Ast Ethernet Controller
• Manufacturer: Standard Microsystems Corp.

I/O SPACE - BANK1
The Configuration Register holds bits that define the adapter configuration and are not expected to
change during run-time. This register is part of the EEPROM-saved setup.
MII SELECT
interface port. When set, the LAN91C100 will
use its MII port and interface a PHY device at
the nibble rate. When clear, the LAN91C100
will use its 10 Mbps ENDEC interface. This bit
drives the MII SEL pin. Switching between ports
should be done with transmitter and receiver
disabled and no transmit/receive packets in
progress.
NO WAIT
additional wait states. An exception to this are
accesses to the Data Register if not ready for a
transfer.
two to three clocks on any cycle to the
LAN91C100.
FULL STEP This bit is a general purpose output
port. Its inverse value drives pin nFSTEP and it
is typically connected to SEL pin of the
LAN83C694C.
signaling mode for the AUI, or as a general
purpose non-volatile configuration pin. Defaults
low.
BYTE
BYTE
HIGH
LOW
OFFSET
0
When clear, negates IOCHRDY for
SELECT
When set, does not request
MII
1
1
1
It can be used to select the
Used to select the network
CONFIGURATION REGISTER
X
0
0
NAME
X
1
RESERVED
NO WAIT
30
0
1
AUI SELECT
output port. Its value drives pin AUISEL and it
is typically connected to MODE1 pin of the
LAN83C694C. It can be used to select AUI vs.
10BASE-T, or as a general purpose non-volatile
configuration pin. Defaults low.
INT SEL1-0
interrupt pins. The three unused interrupts are
tristated.
INT SEL1
X
0
0
0
1
1
READ/WRITE
Used to select one out of four
INT SEL1
TYPE
This bit is a general purpose
STEP
FULL
0
0
INT SEL0
0
1
0
1
INT SEL0
0
0
PIN USED
SYMBOL
INTR0
INTR1
INTR2
INTR3
CR
SELECT
AUI
0
X