ST10F273Z4 STMicroelectronics, ST10F273Z4 Datasheet - Page 151

• Manufacturer Part Number: ST10F273Z4
• Description: 16-BIT MICROCONTROLLER WITH MAC UNIT, UP TO 832 KBYTES FLASH MEMORY AND UP TO 68 KBYTES RAM
• Manufacturer: STMicroelectronics

Specifications of ST10F273Z4

• Single Voltage Supply: 5 V ±10%

ST10F273Z4
Electrical characteristics
Device noise of the circuit in the PLL
The long term jitter is inversely proportional to the bandwidth of the PLL: the wider is the
loop bandwidth, the lower is the jitter due to noise in the loop. Besides, the long term jitter is
practically independent on the multiplication factor.
The most noise sensitive circuit in the PLL circuit is definitively the VCO (Voltage Controlled
Oscillator). There are two main sources of noise: thermal (random noise, frequency
independent so practically white noise) and flicker (low frequency noise, 1/f). For the
2
frequency characteristics of the VCO circuitry, the effect of the thermal noise results in a 1/f
3
region in the output noise spectrum, while the flicker noise in a 1/f
. Assuming a noiseless
2
PLL input and supposing that the VCO is dominated by its 1/f
noise, the R.M.S. value of the
accumulated jitter is proportional to the square root of N, where N is the number of clock
periods within the considered time interval.
On the contrary, assuming again a noiseless PLL input and supposing that the VCO is
3
dominated by its 1/f
noise, the R.M.S. value of the accumulated jitter is proportional to N,
where N is the number of clock periods within the considered time interval.
2
The jitter in the PLL loop can be modelized as dominated by the i1/f
noise for N smaller
than a certain value depending on the PLL output frequency and on the bandwidth
3
characteristics of loop. Above this first value, the jitter becomes dominated by the i1/f
noise
component. Lastly, for N greater than a second value of N, a saturation effect is evident, so
the jitter does not grow anymore when considering a longer time interval (jitter stable
increasing the number of clock periods N). The PLL loop acts as a high pass filter for any
noise in the loop, with cutoff frequency equal to the bandwidth of the PLL. The saturation
value corresponds to what has been called self referred long term jitter of the PLL. In
Figure 44
the maximum jitter trend versus the number of clock periods N (for some typical
CPU frequencies) is reported: the curves represent the very worst case, computed taking
into account all corners of temperature, power supply and process variations: the real jitter
is always measured well below the given worst case values.
Noise in supply and substrate
Digital supply noise adds deterministic components to the PLL output jitter, independent on
multiplication factor. Its effects is strongly reduced thanks to particular care used in the
physical implementation and integration of the PLL module inside the device. Anyhow, the
contribution of the digital noise to the global jitter is widely taken into account in the curves
provided in
Figure
44.
151/188