TXC-06101AILQ Transwitch Corporation, TXC-06101AILQ Datasheet - Page 101

• Manufacturer Part Number: TXC-06101AILQ
• Manufacturer: Transwitch Corporation

Specifications of TXC-06101AILQ

• Operating Temperature (min): -40C
• Operating Temperature Classification: Industrial
• Operating Temperature (max): 85C
• Package Type: PQFP
• Rad Hardened: No
• Lead Free Status / Rohs Status: Not Compliant

Notes:
1. If SPE-only Mode is selected, this control bit has no effect and neither condition occurs.
2. If TTOHEN = "1" or RCLK = "1" then ISC Port Data will be used if Bit Equal to “0”.
3. If STS1 = "1" this control is disabled and B1 Byte value is recalculated.
CONTROL REGISTER 2
Address
Address
(cont.)
0F9
0FA
[H]
[H]
Bit
Bit
2
1
0
7
6
5
Proprietary TranSwitch Corporation Information for use Solely by its Customers
Symbol
RRFRM
Symbol
HWINE
RRB1
STS1
PARA
LTE
Line Terminating Equipment
Enable: defines Line Terminating
Equipment Mode for AIS transmis-
sion and Introduction.
Rx Terminal Port Framing Bytes
Control: Framing Bytes are regen-
erated in Rx Terminal Data.
Rx Terminal Port B1 Byte Con-
trol: B1 Byte is recalculated for Rx
Terminal Data and placed in Rx
TOH Insert RAM Location.
STS-1/STS-N Mode Control:
Line Side in STS-1 Mode. Rx and
Tx Data scrambled. Rx and Tx B1
contains BIP-8 Parity.
Parallel/Serial Mode Control:
Tx Terminal Port is Parallel. Rx Ter-
minal Port has both Serial and Par-
allel Interfaces active.
Hardware Interrupt Enable:
enables Hardware Interrupts via
INT/IRQ Pin
Bit Equal to "1"
Bit Equal to "1"
- 101 of 196 -
DATA SHEET
Conditions
Conditions
defines not Line Terminating Equip-
ment Mode for AIS transmission
and Introduction.
Rx Terminal Data has Framing
Bytes from Rx Line.
outgoing Terminal Data contains
B1 Byte from the Rx Line or the
ISC Port.
Line Side in STS-N Mode. Data is
not scrambled. Rx B1 Byte con-
tains Error indication. Tx B1 Byte
contains Error Mask.
Tx Terminal Port is Serial. Rx Ter-
minal Port has both Serial and Par-
allel Interfaces active.
disables INT/IRQ Pin
Bit Equal to "0"
Bit Equal to "0"
Section Termi-
nating Equip-
ment Mode if
LTE = "0" and
PTE = "0"
Notes 1, 2, 3.
Notes 1, 2, 3
See Table 1.
TXC-06101
Comments
Comments
Ed. 3, April 2001
Notes 1, 2
TXC-06101-MB
PHAST-1