RN-XV Roving Networks Inc, RN-XV Datasheet - Page 30

• Manufacturer Part Number: RN-XV
• Description: MODULE 802.11B/G 2.4GHZ
• Manufacturer: Roving Networks Inc
• Series: -r

Specifications of RN-XV

• Frequency: 2.4GHz
• Data Rate - Maximum: 54Mbps
• Modulation Or Protocol: 802.11b/g
• Applications: General Purpose
• Power - Output: 12dBm
• Sensitivity: -83dBm
• Voltage - Supply: 3 V ~ 3.7 V
• Current - Receiving: 40mA
• Current - Transmitting: 180mA
• Data Interface: PCB, Through Hole
• Memory Size: -
• Antenna Connector: On-Board, Wire Antenna
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1044; RN-XV-W; RN-XVEE; XVEE

8. Action Commands
$$$
close
exit
factory RESET
join <ssid>
join # <num>
leave
lites
lookup <hostname>
open <addr> <port>
ping <g | h | i | addr> <num>
www.rovingnetworks.com
809 University Avenue
•
Los Gatos, CA 95032
enter command mode. X characters are PASSED until this exact sequence
is seen. If any bytes are seen before these chars, or after these chars, in a
250ms window, command mode will not be entered and these bytes will
be passed on to other side.
disconnect a TCP connection.
exit command mode. Exit command mode. “EXIT” will be displayed.
Loads factory defaults into the RAM configuration. Note that the
RESET must be capitalized. This command also writes the settings out
to the standard config file. After this command the module then needs to
be rebooted for settings to take effect.
joins the network <ssid>. If network is security enabled you must set the
pass phrase with the set wlan phrase command prior to issuing the join
command.
NOTE : This command will not work if the ssid has "space » character
join a network from the scan list. <num> is the entry number in the scan
list that is returned from the scan command. If network is security
enabled you must set the pass phrase with the set wlan phrase command
prior to issuing the join command
disconnects the module from the currently associated Access Point.
Blinks LEDs on RN-134 Surf board and RN-370 WiFly serial adapter.
Issue the same command to stop blinking LEDs.
performs a DNS query on the supplied hostname.
opens a TCP connection to the given IP port and address. If no arguments
are provided, the device will attempt to connect to the stored remote host
IP address and remote port number. <addr> can also be a DNS hostname
and will be resolved if entered.
ping remote host. Default sends 1 packet. Optional <num> sends <num>
pings at 10 per second.
Ping 10.20.20.12 10 – pings IP address 10 times
~ 30 ~
•
Tel [phone]
• [e-mail]
WiFly-RN-UM
WiFly GSX/EZX
5/4/2011