RN-XV Roving Networks Inc, RN-XV Datasheet - Page 13

• Manufacturer Part Number: RN-XV
• Description: MODULE 802.11B/G 2.4GHZ
• Manufacturer: Roving Networks Inc
• Series: -r

Specifications of RN-XV

• Frequency: 2.4GHz
• Data Rate - Maximum: 54Mbps
• Modulation Or Protocol: 802.11b/g
• Applications: General Purpose
• Power - Output: 12dBm
• Sensitivity: -83dBm
• Voltage - Supply: 3 V ~ 3.7 V
• Current - Receiving: 40mA
• Current - Transmitting: 180mA
• Data Interface: PCB, Through Hole
• Memory Size: -
• Antenna Connector: On-Board, Wire Antenna
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1044; RN-XV-W; RN-XVEE; XVEE

set comm time <num>
set dns address <addr>
set dns name <string>
set dns backup <string>
set ftp addr <addr>
set ftp dir <string>
set ftp filename <file>
set ftp mode <mask>
set ftp remote <port>
set ftp time <value>
5.4. DNS Parameters
5.5. FTP Parameters
www.rovingnetworks.com
809 University Avenue
•
Los Gatos, CA 95032
sets the flush timer. An IP packet will be sent if no additional bytes are
received for “num” milliseconds. “num” is one milliseconds interval.
Default is 10 (10 milliseconds). Setting this value to 0 will disable
forwarding based on the flush timer.
Flush timer is one of three ways to control TCP/IP packet forwarding.
The others are match character and size. For more information refer to
section on UART Receiver.
sets the IP address of the DNS sever. This is auto-set when using DHCP,
and needs to be set in STATIC IP or Auto-IP modes.
sets the name of the host for TCP/IP connections.
sets the name of the backup host for TCP/IP connections.
set the IP address of the FTP server. By default, the IP address is set to
Roving Networks‟ FTP server (208.109.78.34)
sets the directory to use on the FTP server. Default is “public”. To
read/write to sub-folders, use the “\” for your directory structure. For
example, to read/write to the “test” sub-folder in “demo” directory, the
command is set ftp dir demo\test. To root directory is set by using the
period “.” To se the root directory, the command if set ftp dir .
sets the name of the file transferred when issuing the ftp u command. The
file here refers to the firmware image. If any file other than the firmware
image is set, the WiFly module will download the file and then issue the
UPDATE FAIL=3 error since it is not the firmware image.
sets the ftp mode. Default is passive mode (mode =0x0). Setting
mode=0x1 enables active mode.
sets the ftp server remote port number (default is 21).
sets the ftp timeout value. This timer is used to automatically close the
FTP connection. The timer is 1/8
a timer of 5 seconds, the command is set ftp timer 40. To set the timer to
10 seconds is set ftp timer 80
~ 13 ~
•
Tel [phone]
th
of the actual value. For example, to set
• [e-mail]
WiFly-RN-UM
WiFly GSX/EZX
5/4/2011