RN-XV Roving Networks Inc, RN-XV Datasheet - Page 27

• Manufacturer Part Number: RN-XV
• Description: MODULE 802.11B/G 2.4GHZ
• Manufacturer: Roving Networks Inc
• Series: -r

Specifications of RN-XV

• Frequency: 2.4GHz
• Data Rate - Maximum: 54Mbps
• Modulation Or Protocol: 802.11b/g
• Applications: General Purpose
• Power - Output: 12dBm
• Sensitivity: -83dBm
• Voltage - Supply: 3 V ~ 3.7 V
• Current - Receiving: 40mA
• Current - Transmitting: 180mA
• Data Interface: PCB, Through Hole
• Memory Size: -
• Antenna Connector: On-Board, Wire Antenna
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1044; RN-XV-W; RN-XVEE; XVEE

set q sensor <mask>
set q power <value>
5.12. Sensor Parameters
www.rovingnetworks.com
809 University Avenue
The power is removed immediately after the sampling is complete.
The values used for setting the power are described in the table below:
Example: To set the power to 1.2V automatically upon power up, the
command would be set q power 0x20. To set sensor power to 1.2V when
sampling event occurs, the command is set q power 0x02
Example: To set the power to 3.3V automatically upon power up, the
command would be set q power 0x40. To set sensor power to 3.3V when
sampling event occurs, the command is set q power 0x04
•
Los Gatos, CA 95032
NOTE: The sensor pins variable has been changed from
“set option sensor <mask>” to set q sensor <mask> in ver 2.23
Bitmask value that determines which sensor pins to sample when sending
data using the UDP broadcast packet, or the HTTP auto sample function.
This register is used to automatically turn on the sensor power. This is a 8
bit register with two 4 bit nibbles. If the top nibble is set, then power is
applied upon power up and removed upon power down or sleep.
If the bottom nibble is set, then power is applied when a sampling event
occurs, for example:
 The UDP broadcast
 The auto web posting of sensor data
Value
0
1
2
3
4
Sensor pin voltage
Turn off the sensor power
GROUND the sensor pin
1.2V internal regulated reference
VBATT input pin
3.3V output of on board regulator
~ 27 ~
•
Tel [phone]
• [e-mail]
WiFly-RN-UM
WiFly GSX/EZX
5/4/2011