RN-XV Roving Networks Inc, RN-XV Datasheet - Page 24

• Manufacturer Part Number: RN-XV
• Description: MODULE 802.11B/G 2.4GHZ
• Manufacturer: Roving Networks Inc
• Series: -r

Specifications of RN-XV

• Frequency: 2.4GHz
• Data Rate - Maximum: 54Mbps
• Modulation Or Protocol: 802.11b/g
• Applications: General Purpose
• Power - Output: 12dBm
• Sensitivity: -83dBm
• Voltage - Supply: 3 V ~ 3.7 V
• Current - Receiving: 40mA
• Current - Transmitting: 180mA
• Data Interface: PCB, Through Hole
• Memory Size: -
• Antenna Connector: On-Board, Wire Antenna
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1044; RN-XV-W; RN-XVEE; XVEE

set wlan join <value>
set wlan hide <0, 1>
set wlan key <value>
www.rovingnetworks.com
809 University Avenue
sets the policy for automatically joining/associating with network access
points. This policy is used when the module powers up, including wake up
from the sleep timer.
•
Los Gatos, CA 95032
Hides the WEP key and WPA passphrase. When set, displaying the wlan
settings shows ****** for these fields. To unhide the passphrase or
passkey, re-enter the key or passphrase using the set wlan key or set wlan
passphrase command. Default = 0, don‟t hide.
sets the 128 bit WEP key. If you are using WPA or WPA2 you should
enter a pass phrase with the set wlan passphase command. Key must be
EXACTLY 13 bytes (26 ASCII chars). Data is expected in HEX format,
“0x” should NOT be used here.
Example : “set w k 112233445566778899AABBCCDD”
Hex digits > 9 can be either upper or lower case.
The Wifly GSX only supports “open” key mode, 128 bit keys for WEP.
WEP-128, shared mode is not supported as it is known to be easily
compromised and has been deprecated from the WiFi standards.
Value
0
1
2
3
4
Policy
Manual, do not try to join automatically
~ 24 ~
Try to join the access point that matches the stored
SSID, passkey and channel. Channel can be set to
0 for scanning. (Default)
Join ANY access point with security matching the
stored authentication mode. This ignores the stored
SSID and searches for the access point with the
strongest signal. The channels searched can be
limited by setting the channel mask.
Reserved – Not used
Create an Adhoc network, using stored SSID, IP
address and netmask. Channel MUST be set.
DHCP should be 0 (static IP) or set to Auto-IP with
this policy. (unless another Adhoc device can act as
DHCP server)
This policy is often used instead of the hardware
jumper to creat a custom Adhoc network
•
Tel [phone]
• [e-mail]
WiFly-RN-UM
WiFly GSX/EZX
5/4/2011