RN-XV Roving Networks Inc, RN-XV Datasheet - Page 17

• Manufacturer Part Number: RN-XV
• Description: MODULE 802.11B/G 2.4GHZ
• Manufacturer: Roving Networks Inc
• Series: -r

Specifications of RN-XV

• Frequency: 2.4GHz
• Data Rate - Maximum: 54Mbps
• Modulation Or Protocol: 802.11b/g
• Applications: General Purpose
• Power - Output: 12dBm
• Sensitivity: -83dBm
• Voltage - Supply: 3 V ~ 3.7 V
• Current - Receiving: 40mA
• Current - Transmitting: 180mA
• Data Interface: PCB, Through Hole
• Memory Size: -
• Antenna Connector: On-Board, Wire Antenna
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1044; RN-XV-W; RN-XVEE; XVEE

set opt replace <char>
set opt deviceid <string>
set opt password <string>
set sys autoconn <value>
5.8. System Parameters
www.rovingnetworks.com
809 University Avenue
•
Los Gatos, CA 95032
replacement character for spaces. The replacement character is used when
entering SSID and pass phrases that include space. This is used by the
WiFly command parser only. Each occurrence of the replacement
character is changed into a space. The default is “$” (0x24)
Configurable Device ID - can be used for storing serial numbers, product
name or other device information. This information is sent as part of the
broadcast hello packet that is sent as a UDP. The current value can be
shown with the “get option” or “show deviceid” commands. Max string
size is 32 bytes. The default is “WiFly-GSX”.
TCP connection password. Provides minimal authentication by requiring
any remote device that connects to send and match a challenge <string>.
When set, all newly opened connections must first send the exact
characters that match the stored password otherwise the WiFly module
will close the connection. When the password is set the WiFly module
sends the string “PASS?” to the remote host. All characters in the string
must be sent in one TCP packet. Max string size is 32 bytes. To disable
the password feature use string=0 which is the default.
TCP mode: sets the auto connect timer. This command causes the module
periodically connect to the stored remote host. The timer <value>
determines how often to connect to the stored remote host. Default=0
Value
0
1
2-254
255
NOTE: To use the auto connect timer, the remote host‟ IP address and
port must be stored in the WiFly module using the
set ip host <IP address> and set ip remote <port> commands.
Description
Disable auto connect timer
Connect to the stored host IMMEDIATELY upon
power up or wake from sleep state
Connect to a stored host every <value> number of
seconds
Connect to a stored host IMMEDIATELY upon
power up or wake from sleep state and go back to
sleep IMMEDIATELY as soon as TCP connection
is closed
~ 17 ~
•
Tel [phone]
• [e-mail]
WiFly-RN-UM
WiFly GSX/EZX
5/4/2011