LAN9311-NU SMSC, LAN9311-NU Datasheet - Page 84

• Manufacturer Part Number: LAN9311-NU
• Description: IC ETHER SW 2PRT 16BIT 128-VTQFP
• Manufacturer: SMSC
• Type: Two Port Managed Ethernet Switchr

Specifications of LAN9311-NU

• Controller Type: Ethernet Switch Controller
• Interface: Serial EEPROM
• Voltage - Supply: 3.3V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 128-TQFP, 128-VQFP
• Product: Ethernet Switches
• Number Of Transceivers: 1
• Standard Supported: 802.3, 802.3u
• Data Rate: 10 MB, 100 MB
• Supply Voltage (max): 3.3 V
• Supply Voltage (min): 0 V
• Maximum Operating Temperature: + 70 C
• Ethernet Connection Type: 10 Base-T, 100 Base-TX
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• For Use With: 638-1076 - EVALUATION BOARD LAN9311-NU
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 638-1075

Revision 1.7 (06-29-10)
7.2.1
7.2.1.1
7.2.1.2
Port x
MAC
Converter
NRZI
100BASE-TX Transmit
The 100BASE-TX transmit data path is shown in
internal to the PHY. Each major block is explained in the following sections.
MII MAC Interface
For a transmission, the switch fabric MAC drives the transmit data to the PHYs MII MAC Interface.
The MII MAC Interface is described in detail in
Note: The PHY is connected to the switch fabric MAC via standard MII signals. Refer to the IEEE
4B/5B Encoder
The transmit data passes from the MII block to the 4B/5B Encoder. This block encodes the data from
4-bit nibbles to 5-bit symbols (known as “code-groups”) according to
is mapped to 16 of the 32 possible code-groups. The remaining 16 code-groups are either used for
control information or are not valid.
The first 16 code-groups are referred to by the hexadecimal values of their corresponding data nibbles,
0 through F. The remaining code-groups are given letter designations with slashes on either side. For
example, an IDLE code-group is /I/, a transmit error code-group is /H/, etc.
RJ45
MII 25 MHz by 4 bits
MII Transmit Clock
802.3 specification for additional details.
NRZI
Internal
Internal
MLT-3
Converter
MLT-3
Figure 7.2 100BASE-TX Transmit Data Path
MII MAC
Interface
CAT-5
100M
PLL
MLT-3
DATASHEET
125 Mbps Serial
MLT-3
by 4 bits
84
25MHz
Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
TX Driver
100M
Section 7.2.7, "MII MAC
Figure
Encoder
4B/5B
7.2. Shaded blocks are those which are
MLT-3
Table
25MHz by
Magnetics
5 bits
Interface".
7.2. Each 4-bit data-nibble
SMSC LAN9311/LAN9311i
Scrambler
and PISO
Datasheet