CS1D-BC042D Omron, CS1D-BC042D Datasheet - Page 33

• Manufacturer Part Number: CS1D-BC042D
• Description: CS1D Dual CPU Exp
• Manufacturer: Omron

Specifications of CS1D-BC042D

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

xxxiv
6-4
Countermeasures
Countermeasure Examples
Conformance to EC Directives
CR method
Power
supply
Circuit
Relay Output Noise Reduction Methods
Yes
AC
Current
Yes
DC
The CS1D Duplex PLCs conforms to the Common Emission Standards
(EN61000-6-4) of the EMC Directives. However, noise generated by relay out-
put switching may not satisfy these Standards. In such a case, a noise filter
must be connected to the load side or other appropriate countermeasures
must be provided external to the PLC.
Countermeasures taken to satisfy the standards vary depending on the
devices on the load side, wiring, configuration of machines, etc. Following are
examples of countermeasures for reducing the generated noise.
(Refer to EN61000-6-4 for more details.)
Countermeasures are not required if the frequency of load switching for the
whole system with the PLC included is less than 5 times per minute.
Countermeasures are required if the frequency of load switching for the whole
system with the PLC included is more than 5 times per minute.
When switching an inductive load, connect an surge protector, diodes, etc., in
parallel with the load or contact as shown below.
If the load is a relay or solenoid, there is
a time lag between the moment the cir-
cuit is opened and the moment the load
is reset.
If the supply voltage is 24 or 48 V, insert
the surge protector in parallel with the
load. If the supply voltage is 100 to
200 V, insert the surge protector
between the contacts.
Characteristic
The capacitance of the capacitor must
be 1 to 0.5 F per contact current of
1 A and resistance of the resistor must
be 0.5 to 1
These values, however, vary with the
load and the characteristics of the
relay. Decide these values from experi-
ments, and take into consideration that
the capacitance suppresses spark dis-
charge when the contacts are sepa-
rated and the resistance limits the
current that flows into the load when
the circuit is closed again.
The dielectric strength of the capacitor
must be 200 to 300 V. If the circuit is an
AC circuit, use a capacitor with no
polarity.
Required element
per contact voltage of 1 V.
6