CS1W-CRM21 Omron, CS1W-CRM21 Datasheet - Page 115

• Manufacturer Part Number: CS1W-CRM21
• Description: CS1 CompoNet Master
• Manufacturer: Omron

Specifications of CS1W-CRM21

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

2-3
2-3-1
2-3-2
2-3
Uploading the Serial Network Configuration Connected to a CPU Unit
Uploading Network Configurations and Checking for Communications Unit Errors
Uploading Network Configurations and Checking
for Communications Unit Errors
Overview
Procedure
CompoWay/F Networks
With the CX-Integrator, the actual network configuration including component
parameters can be uploaded from the target PLC and displayed in the Network
Configuration Window.
Note: The network that is uploaded will be automatically added to the Workspace Window.
After uploading the network, check the connection status of the nodes and check the
status of Communications Units (check for errors).
Right-click a Communications Unit or port below TargetDevice in the Online Connection
Information Window and select Connect from the pop-up menu. Accessing the
Communications Unit or port will be enabled and the icon to the left will change to
(If the network has been uploaded but a network address is not displayed (Net(-)
displayed), it will be necessary to select the desired network in the Workspace Window,
right-click, and select Connect.)
Then select Transfer [Network to PC].
Note: When uploading the network configuration of a target PLC through the relay PLC, select
Right-click a CPU Unit under TargetPLC in the Online Connection Information Window
and select Connect from the pop-up menu. The serial port will become accessible.
(If the network has been uploaded but a network address is not displayed (Net(-)
displayed), it will be necessary to select the desired network in the Workspace Window,
right-click, and select Connect.)
Right-click the CPU Unit again and then select Transfer [Network to PC].
Refer to 8-2 CompoWay/F Slaves Connected to a PLC for details.
Computer running
CX-Integrator
Relay PLC
and right-click the desired target PLC on the network and select Connect to this PLC from
the pop-up menu to make that PLC the target PLC. Refer to 2-4 Switching the Target
PLC for details.
Upload
Network Configuration Window
CS/CJ Series PLC
Target PLC
Access must be enabled by executing Connect.
Example: Controller Link
2-3-1
Overview
2-23
.