XBP09-DPSIT-156 Digi International, XBP09-DPSIT-156 Datasheet - Page 50

• Manufacturer Part Number: XBP09-DPSIT-156
• Description: MODULE XBEE PRO W/RPSMA
• Manufacturer: Digi International
• Series: XBEE-PRO™r

Specifications of XBP09-DPSIT-156

• Frequency: 902MHz ~ 928MHz
• Data Rate - Maximum: 156kbps
• Modulation Or Protocol: FHSS
• Applications: ISM
• Power - Output: 17dBm (50mW)
• Sensitivity: -100dBm
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Receiving: 80mA
• Current - Transmitting: 210mA
• Data Interface: PCB, Through Hole
• Antenna Connector: RP-SMA
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 602-1169

XBee‐PRO® 900 RF Modules
The broadcast radius can be set from 0 up to NH to 0xFF. If the broadcast radius exceeds the value
of NH then the value of NH will be used as the radius. This parameter is only used for broadcast
transmissions.
The maximum number of payload bytes can be read with the NP command.
Example: The above example sends a data transmission to a radio with a 64 bit address of
0x0013A20001238400 using a source endpoint of 0xA0, destination endpoint 0xA1, cluster ID
=0x1554, and profile ID 0xC105. Payload will be "TxData".
A
P
I
P
a
c
k
e
t
© 2009 Digi International, Inc.
Start Delimiter
Length
Frame-specific Data
Checksum
Frame Fields
Frame Type
Frame ID
64-bit Destination
Address
Reserved
Source Endpoint
Destination Endpoint
Cluster ID
Profile ID
Broadcast Radius
Transmit Options
Data Payload
Offset Example
MSB 1 0x00
MSB 5 0x00
LSB12 0x00
LSB 2 0x1A
10 0x23
13 0xFF
14 0xFE
15 0xA0
16 0xA1
17 0x15
18 0x54
19 0xC1
20 0x05
21 0x00
22 0x00
23 0x54
24 0x78
25 0x44
26 0x61
27 0x74
28 0x61
29 0xDD
11 0x84
0 0x7E
3 0x11
4 0x01
6 0x13
7 0xA2
8 0x00
9 0x01
Number of bytes between the length and the checksum
Identifies the UART data frame for the host to correlate
with a subsequent ACK (acknowledgement). If set to 0,
no response is sent.
Set to the 64-bit address of the destination device. The
following address is also supported:
0x000000000000FFFF - Broadcast address
Set to 0xFFFE.
Source endpoint for the transmission.
Destination endpoint for the
transmission.
Cluster ID used in the transmission
Profile ID used in the transmission
Sets the maximum number of hops a broadcast
transmission can traverse. If set to 0, the transmission
radius will be set to the network maximum hops value.
Bitfield:
bit 0: Disable ACK
bit 1: Don't attempt route Discovery.
All other bits must be set to 0.
0xFF - the 8 bit sum of bytes from offset 3 to this byte.
Description
50