ATA5773-DK1 Atmel, ATA5773-DK1 Datasheet - Page 65

• Manufacturer Part Number: ATA5773-DK1
• Description: BOARD XMITTER FOR ATA5773 315MHZ
• Manufacturer: Atmel
• Type: Transmitterr

Specifications of ATA5773-DK1

• Frequency: 315MHz
• Maximum Frequency: 315 MHz
• Supply Voltage (max): 4 V
• Supply Voltage (min): 2 V
• Supply Current: 9 mA
• Product: RF Development Tools
• For Use With/related Products: ATA5773
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

4.14.2.5
4.14.2.6
9137E–RKE–12/10
Digital Input Enable and Sleep Modes
Unconnected Pins
Note:
As shown in
input of the schmitt-trigger. The signal denoted SLEEP in the figure, is set by the MCU Sleep
Controller in Power-down mode, Power-save mode, and Standby mode to avoid high power
consumption if some input signals are left floating, or have an analog signal level close to
V
SLEEP is overridden for port pins enabled as external interrupt pins. If the external interrupt
request is not enabled, SLEEP is active also for these pins. SLEEP is also overridden by vari-
ous other alternate functions as described in
page
If a logic high level (“one”) is present on an asynchronous external interrupt pin configured as
“Interrupt on Rising Edge, Falling Edge, or Any Logic Change on Pin” while the external inter-
rupt is not enabled, the corresponding External Interrupt Flag will be set when resuming from
the above mentioned Sleep mode, as the clamping in these sleep mode produces the
requested logic change.
If some pins are unused, it is recommended to ensure that these pins have a defined level.
Even though most of the digital inputs are disabled in the deep sleep modes as described
above, floating inputs should be avoided to reduce current consumption in all other modes
where the digital inputs are enabled (Reset, Active mode and Idle mode).
The simplest method to ensure a defined level of an unused pin, is to enable the internal
pull-up. In this case, the pull-up will be disabled during reset. If low power consumption during
reset is important, it is recommended to use an external pull-up or pulldown. Connecting
unused pins directly to V
rents if the pin is accidentally configured as an output.
CC
/2.
66.
1. For the assembly program, two temporary registers are used to minimize the time from
pull-ups are set on pins 0, 1 and 4, until the direction bits are correctly set, defining bit 2 and
3 as low and redefining bits 0 and 1 as strong high drivers.
Figure 4-22 on page
CC
or GND is not recommended, since this may cause excessive cur-
61, the digital input signal can be clamped to ground at the
Section 4.14.3 “Alternate Port Functions” on
Atmel ATA5771/73/74
65