PIC32MX210F016B-I/SO Microchip Technology, PIC32MX210F016B-I/SO Datasheet - Page 220

• Manufacturer Part Number: PIC32MX210F016B-I/SO
• Description: PIC32, 16KB Flash, 4KB RAM, 40 MHz, USB, CTMU, 4 DMA 28 SOIC .300in TUBE
• Manufacturer: Microchip Technology

REGISTER 24-1:
DS61168D-page 220
bit 10
bit 9
bit 8
bit 7-2
bit 1-0
Note 1:
2:
3:
4:
EDGSEQEN: Edge Sequence Enable bit
1 = Edge1 must occur before Edge2 can occur
0 = No edge sequence is needed
IDISSEN: Analog Current Source Control bit
1 = Analog current source output is grounded
0 = Analog current source output is not grounded
CTTRIG: Trigger Control bit
1 = Trigger output is enabled
0 = Trigger output is disabled
ITRIM<5:0>: Current Source Trim bits
011111 = Maximum positive change from nominal current
011110
•
•
•
000001 = Minimum positive change from nominal current
000000 = Nominal current output specified by IRNG<1:0>
111111 = Minimum negative change from nominal current
•
•
•
100010
100001 = Maximum negative change from nominal current
IRNG<1:0>: Current Range Select bits
11 = 100 times base current
10 = 10 times base current
01 = Base current level
00 = 1000 times base current
When this bit is set for Pulse Delay Generation, the EDG2SEL<2:0> bits must be set to ‘1110’ to select
C2OUT.
The ADC module Sample and Hold capacitor is not automatically discharged between sample/conversion
cycles. Software using the ADC as part of a capacitive measurement, must discharge the ADC capacitor
before conducting the measurement. The IDISSEN bit, when set to ‘1’, performs this function. The ADC
module must be sampling while the IDISSEN bit is active to connect the discharge sink to the capacitor
array.
Refer to the CTMU Current Source Specifications
Characteristics”
This bit setting is not available for the CTMU temperature diode.
CTMUCON: CTMU CONTROL REGISTER (CONTINUED)
for current values.
(4)
(3)
Preliminary
(2)
(Table
29-39) in
Section 29.0 “Electrical
© 2011-2012 Microchip Technology Inc.